AM29F010A-45JC AMD (ADVANCED MICRO DEVICES), AM29F010A-45JC Datasheet - Page 16

• Manufacturer Part Number: AM29F010A-45JC
• Manufacturer: AMD (ADVANCED MICRO DEVICES)

Specifications of AM29F010A-45JC

• Lead Free Status / Rohs Status: Not Compliant

DQ5: Exceeded Timing Limits
DQ5 indicates whether the program or erase time has
exceeded a specified internal pulse count limit. Under
these conditions DQ5 produces a “1.” This is a failure
condition that indicates the program or erase cycle was
not successfully completed.
The DQ5 failure condition may appear if the system
tries to program a “1” to a location that is previously
programmed to “0.” Only an erase operation can
change a “0” back to a “1.” Under this condition, the
device halts the operation, and when the operation has
exceeded the timing limits, DQ5 produces a “1.”
Under both these conditions, the system must issue
the reset command to return the device to reading
array data.
DQ3: Sector Erase Timer
After writing a sector erase command sequence, the
system may read DQ3 to determine whether or not an
erase operation has begun. (The sector erase timer
does not apply to the chip erase command.) If addi-
Notes:
1. DQ7 requires a valid address when reading status information. Refer to the appropriate subsection for further details.
2. DQ5 switches to ‘1’ when an Embedded Program or Embedded Erase operation has exceeded the maximum timing limits.
16
Standard
Mode
Erase
Suspend
Mode
See “DQ5: Exceeded Timing Limits” for more information.
Embedded Program Algorithm
Embedded Erase Algorithm
Reading within Erase Suspended Sector
Reading within Non-Erase Suspended Sector
Operation
Table 5. Write Operation Status
Am29F010A
tional sectors are selected for erasure, the entire time-
out also applies after each additional sector erase com-
mand. When the time-out is complete, DQ3 switches
from “0” to “1.” The system may ignore DQ3 if the sys-
tem can guarantee that the time between additional
sector erase commands will always be less than 50 µs.
See also the “Sector Erase Command Sequence”
section.
After the sector erase command sequence is written,
the system should read the status on DQ7 (Data# Poll-
ing) or DQ6 (Toggle Bit I) to ensure the device has
accepted the command sequence, and then read DQ3.
If DQ3 is “1”, the internally controlled erase cycle has
begun; all further commands are ignored until the
erase operation is complete. If DQ3 is “0”, the device
will accept additional sector erase commands. To en-
sure the command has been accepted, the system
software should check the status of DQ3 prior to and
following each subsequent sector erase command. If
DQ3 is high on the second status check, the last com-
mand might not have been accepted. Table 5 shows
the outputs for DQ3.
(Note 1)
DQ7#
DQ7
Data
0
1
No toggle
Toggle
Toggle
DQ6
Data
(Note 2)
DQ5
Data
0
0
0
DQ3
Data
N/A
N/A
1