CC-9P-V526UJ-EA Digi International, CC-9P-V526UJ-EA Datasheet - Page 93

• Manufacturer Part Number: CC-9P-V526UJ-EA
• Description: MOD 9P 9215 CONNCORE 8MB FLASH
• Manufacturer: Digi International
• Series: -r

Specifications of CC-9P-V526UJ-EA

• Module/board Type: Core Module
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: Networking

93
I E E E 8 0 2 . 1 1 a / b / g W L A N
W W A N A c t i v i t y
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ConnectCore 9P 9215, Wi-9P 9215, and 3G 9P 9215 Hardware Reference
A
The ConnectCore Wi-9P 9215 provides access to an IEEE802.11a/b/g WLAN
interface. The whole circuitry is located on the module. The user can track WLAN
activity through the WLAN-LED# signal. The user can also disable the RF power
amplifier by activating the WLAN-DISABLE# signal.
Two U.FL connectors are available for dual-diversity.
The WLAN baseband controller can be reset through GPIO92. When this signal is low,
the baseband controller is in reset mode. When high, the controller is active.
The interrupt signal connected to the baseband controller is GPIO_AO.
The ConnectCore3G 9P 9215 provides access to a PCIe 3G module. The whole
circuitry is located on the module. The user can track WWAN activity through the
WLAN-LED# signal. The user can also disable the PCIe module by activating the
WLAN-DISABLE# signal.
Not including the Gobi modem there are three U.FL connectors for a WWAN antenna
and a GPS antenn available on the ConnectCore 3G 9P 9215 module. Including the
Gobi modem there are five U.FL connectors available.
The PCIe power supply can be controlled through GPIO0 of the onboard OXU210 USB
controller. When this signal is low, the PCIe power is off.
The PCIe reset signal PCIE_RESET# is connected to GPIO_AO.