CC-9P-V526UJ-EA Digi International, CC-9P-V526UJ-EA Datasheet - Page 40

• Manufacturer Part Number: CC-9P-V526UJ-EA
• Description: MOD 9P 9215 CONNCORE 8MB FLASH
• Manufacturer: Digi International
• Series: -r

Specifications of CC-9P-V526UJ-EA

• Module/board Type: Core Module
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: Networking

www.digiembedded.com
SPI
I
RTC
WLAN
WWAN
ADC
FIM
2
C bus
C h a p t e r 1
The module supports baud rates up to 1.8432 Mbps in asynchronous mode. Each
UART has a 64-byte TX and RX FIFO available.
The following interfaces are only available on the ConnectCore 9P 9215 and
ConnectCore Wi-9P 9215.
The module provides one SPI port which can be used in either master or slave mode.


The SPI module is made of four signals: RXD, TXD, CLK and CS#
The I
is in the processor.
The I²C clock is max 400kHz.
I2C signals are provided on the module with 4k7 pull-up resistors.
The RTC is integrated in the processor and has its own 32.768 KHz clock crystal.



In addition to the wired Ethernet interface, the ConnectCore Wi-9P 9215 module also
offers an integrated dual-diversity 802.11a/b/g interface with data rates up to 54
Mbps. Two U.FL antenna connectors are provided on the module.
The ConnectCore 3G 9P 9215 offers 3G connection technologies by using the
Qualcomm Gobi PCIe module.
The ADC on the module provides 12-bit resolution / 1 MHz conversion capabilities,
single-ended 8:1 multiplexed inputs, rail-to-rail input range, 12-bit output
(DMA/direct), and external reference.
The Flexible Interface Modules (FIM) are based on two independent 8-bit DRPIC1655X
cores running at 300 MHz maximum core clock (4x NS9215 bus speed) with 192-byte
data and 2 KB program SRAM. The FIMs allow the flexible software-based selection of
Master: 33.33 Mbps
Slave: 7.50 Mbps
When powered by VBAT, RTC unit will function until VBAT (X1.78) reaches a
threshold of 2.3 - 2.4V - then the internal unit switches off.
The battery current without +3.3V power applied is up to 40µA. The current is
used to power the RTC, 32.768kHz oscillator and 64-byte internal RAM.
When the Development Board ships from the factory the battery is disabled. To
enable the battery, place a jumper on the Development Board at J2.
2
C bus is completely free on the module - no EEPROM and no RTC - since the RTC
40