C4V-811M-D Omron, C4V-811M-D Datasheet - Page 3

• Manufacturer Part Number: C4V-811M-D
• Description: Control Switches Mini Power, SPST Momentary Action
• Manufacturer: Omron
• Series: C4Vr
• Type: Standardr

Specifications of C4V-811M-D

• Circuit: SPST-NO
• Switch Function: Off-Mom
• Contact Rating @ Voltage: 8A @ 125VAC
• Actuator Type: Plunger
• Illumination Type, Color: -
• Illumination Voltage (nominal): -
• Mounting Type: Panel Mount
• Termination Style: Quick Connect - .187" (4.7mm)
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Precautions
■ Warning
Electric shock may possibly occur, do not perform wiring or touch the
charged parts of terminals while power is supplied to the Switch.
■ Cautions
Use the switch within the rated voltage and current ranges, otherwise
the switch may have a shortened life expectancy, radiate heat, or
burn out. This particularly applies to the instantaneous voltages and
currents when switching.
■ Correct Use
Insulation in switch mounting
Paying attention to creepage distance/clearance distance for insula-
tion after wiring onto terminal when a mounting frame is made of
metal.
Wiring for switch
• Please use the receptacle that suits 4.8 × 0.8mm tab terminal
• Be sure that the wires are thick enough for the load (current) to be
• The performance of the Switch may be affected if the Switch is
• When soldering terminals manually, perform soldering within 5 s
• Applying the tip of the soldering iron to the root side of the terminal
• This product doesn't correspond to the reflow solder and flow sol-
Environment for Storage and Use
To prevent discoloration of the terminals and other problems during
storage, do not store the switch in locations subject to the following
conditions.
Also, the switch is not waterproof or splash-resistant. Do not install or
use the switch in locations that are subject to contact with water.
Do not subject the switch to freezing or condensation.
(#187) when using it as a tab terminal.
applied.
used under micro loads. Test the Switch under the actual operating
conditions.
It is possible to use the terminals as soldering terminal. But, it is not
in compliance with safety standards for use as solder connection.
Only the quick-connect terminals is in compliance with Safety stan-
dards.
using a 60W soldering iron (temperature at the tip of the soldering
iron: 360 degC max). Do not apply excessive force to the terminals
during soldering.
can be a cause of deformation of the external portions that is the
Housing and Base.
der. It causes the malfunction by the infiltration of flux and the ther-
mal deformation.
1. High temperatures or humidity
2. Corrosive gases
3. Direct sunlight
4. Sea wind
Handling
When handling the product, any shock like drop should not be
applied to it. Shock can cause break or deformation of the product.
Do not apply excessive operating force to the switch. Otherwise the
switch may be damaged or deformed, and the switch mechanism
may malfunction as a result. Apply an operating force not exceeding
30N. Do not apply a load from an angle or from the side of the actua-
tor.
RoHS Compliant
The "RoHS Compliant" designation indicates that the listed models
do not contain the six hazardous substances covered by the RoHS
Directive.
Reference: The following standards are used to determine compli-
ance for the six substances.
Lead:
Mercury:
Cadmium:
Hexavalent chromium:
PBB:
PBDE:
Miniature Power Switch
1,000 ppm max.
1,000 ppm max.
100 ppm max.
1,000 ppm max.
1,000 ppm max.
1,000 ppm max.
C4V
3