EMC2103-2-AP-TR Standard Microsystems (SMSC), EMC2103-2-AP-TR Datasheet - Page 13

• Manufacturer Part Number: EMC2103-2-AP-TR
• Description: CLOSED LOOP RPM FAN CONTROLLER
• Manufacturer: Standard Microsystems (SMSC)

RPM-Based Fan Controller with HW Thermal Shutdown
Datasheet
Chapter 3 Electrical Characteristics
SMSC EMC2103
Voltage on 5V tolerant pins
Voltage on VDD pin
Voltage on any other pin to GND
Package Power Dissipation
Junction to Ambient (θ
Operating Ambient Temperature Range
Storage Temperature Range
ESD Rating, All Pins, HBM
Note: Stresses above those listed could cause permanent damage to the device. This is a stress
Note: All voltages are relative to ground.
Note: θ
rating only and functional operation of the device at any other condition above those indicated
in the operation sections of this specification is not implied. When powering this device from
laboratory or system power supplies, it is important that the Absolute Maximum Ratings not be
exceeded or device failure can result. Some power supplies exhibit voltage spikes on their
outputs when the AC power is switched on or off. In addition, voltage transients on the AC
power line may appear on the DC output. If this possibility exists, it is suggested that a clamp
circuit be used.
ground.
JA
JA
numbers are based on a recommended four 12 mil vias connecting the thermal pad to PCB
)
Table 3.1 Absolute Maximum Ratings
DATASHEET
13
-0.3 to 5.5
-0.3 to 4
-0.3 to V
0.8W up to T
50
-40 to 125
-55 to 150
2000
DD
+ 0.3
A
= 85°C
Revision 0.88 (06-30-08)
V
V
V
W
°C/W
°C
°C
V