LQ035Q1DH01 Sharp Electronics, LQ035Q1DH01 Datasheet - Page 26

• Manufacturer Part Number: LQ035Q1DH01
• Manufacturer: Sharp Electronics

Specifications of LQ035Q1DH01

• Lead Free Status / Rohs Status: Compliant

11-4. Cautions in assembly / Handling pre cautions
As the polarizer can be easily scratched, be most careful in handling it.
1) Work environments in assembly.
2) How the remove dust on the polarizer
3) In the case of the module’s metal part (shield case) is stained, wipe it with a piece of dry, soft cloth.
a) Implement more than 1M conductive treatment (by placing a conductive mat or applying conductive
b) No dusts come in to the working room. Place an adhesive, anti-dust mat at the entrance of the room.
c) Humidity of 50 to 70% and temperature of 15 to 27 C are desirable.
d) All workers wear conductive shoes, conductive clothes, conductive fingerstalls and grounding belts
e) Use a blower for electrostatic removal. Set it in a direction slightly tilt downward so that each Module
a) Blow out dust by the use of an N2 blower with antistatic measures taken. Use of an ionized air Gun is
b) When the panel surface is soiled, wipe it with soft cloth.
If rather difficult, give a breath on the metal part to clean better.
b) Mounting on display and housing bezel
Working under the following environments is desirable:
(1) In all cases, the T/P should be supported from the backside of the Plastic.
(2) Do not to use an adhesive-tape to bond it on the front of T/P and hang it to the housing bezel.
(3) Never expand the T/P top layer (PET-film) like a balloon by internal air pressure.
(4) Top layer, PET, dimension is changing with environmental temperature and humidity.
(5) The input to the touch panel sometimes distorts touch panel itself.
paint) on the floor or tiles.
without fail.
can be well subjected to its wind. Set the blower at an optimum distance between the blower and the
module.
recommendable.
Insulation Paste
The life of the T/P will be extremely short.
Avoid a stress from housing bezel to top layer, because it may cause “waving”.
Insulation
Cushion material
(=Cushion Area)
Transparent
PET Film
Glass
metal
Housing
Prohibition Area
Fig.11-3-1
Key Area
LCY-W-07201
Electrode
Layer
0.3 to 0.7mm
Page 24 of 29