NL8060BC26-17 NEC Electronics, NL8060BC26-17 Datasheet - Page 20

• Manufacturer Part Number: NL8060BC26-17
• Manufacturer: NEC Electronics

Specifications of NL8060BC26-17

• Lead Free Status / Rohs Status: Not Compliant

GENERAL CAUTIONS
completely.
(1) Caution when taking out the module
(2) Cautions for handling the module
(3) Cautions regarding atmosphere
(4) Cautions about module characteristics
20
The figures and statements below are very important. Please be sure you understand their contents
<1>
<2>
<3>
<4>
<1>
<2>
<3>
<4>
<1>
<1>
<2>
<3>
<4>
<5>
<6>
<7>
<8>
<9>
<10> Do not give any stress to the interface connector.
CAUTION
CAUTION
Pick up the pouch only, when removing the module from a carrier box.
As electrostatic discharges may break the LCD module, handle the LCD module with care against
electrostatic discharges.
As the surface of the polarizer is very soft and easily scratched, use a soft dry cloth without chemicals
for cleaning.
Do not pull the interface connectors in or out while the LCD module is operating.
Put the module display side down on a flat horizontal plane.
Handle connectors and cables with care.
When the module is operating, do not lose the CLK, Hsync, or Vsync signal. If any one of these signals
is lost, the LCD panel will be damaged.
The torque for mounting screws should never exceed 0.294 N·m (3 kgf·cm).
Don’t push or rub the surface of the LCD module.
If you do, scratches or rubbing marks may be left on the surface of the module.
Dew-drop atmosphere must be avoided.
Do not store and/or operate the LCD module in a high-temperature and/or high-humidity atmosphere.
Storage in an electro-conductive polymer packing pouch and in a relatively low-temperature atmosphere
is recommended.
This module uses cold cathode fluorescent lamps. Therefore, the lifetime of the lamp is shortened
conspicuously at very low temperatures.
Do not operate the LCD module in a high magnetic field.
Do not apply any fixed-pattern data signals to the LCD module at product aging. Applying a fixed pattern
for a long time may cause image sticking.
This module has retardation film, which may cause variation of the color hue at different viewing angles.
Nonuniformity may appear on the screen during high-temperature operation.
A light vertical stripe may be observed, depending on the display pattern. This is not a defect or a
malfunction.
Noise from the inverter circuit may be observed in the luminance control mode. This is not a defect or
a malfunction.
This figure indicates that you will get hurt if you make a mistake in operation.
As the LCD panel and backlight element are made from fragile glass material, impact and
pressure to the LCD module should be avoided.
This mark indicates that you will get hurt and/or the module will be damaged if you make a
mistake in operation.
Data Sheet EN0493EJ1V1DS00
NL8060BC26-17