AD7769JP-REEL Analog Devices Inc, AD7769JP-REEL Datasheet - Page 10

• Manufacturer Part Number: AD7769JP-REEL
• Manufacturer: Analog Devices Inc

Specifications of AD7769JP-REEL

• Lead Free Status / Rohs Status: Supplier Unconfirmed

AD7769
3. If RD is held low but CS is taken high during the conversion,
4. Note that the state of RD should not be changed during a
Figure 11. Timing for ADC Channel Select and Conversion
Start
Figure 13. Timing for DAC Channel Select and Data Write
the device will be de-selected and DB0–DB7 will revert to
their high impedance state. This will not affect completion of
the conversion, but the data cannot be read, or any other
operation performed, until CS is taken low again.
conversion.
Figure 12. Timing for ADC Data Read
–10–
DIGITAL SIGNAL PROCESSING APPLICATIONS
In Digital Signal Processing (DSP) application areas like voice
recognition, echo cancellation and adaptive filtering, the dy-
namic characteristics (SNR, Harmonic Distortion, Intermodula-
tion Distortion) of both the ADC and DACs are critical. The
AD7769 is specified dynamically as well as with standard dc
specifications. Because the track/hold amplifier has a wide band-
width, an antialiasing filter should be placed on the V
V
the bands of interest.
The dynamic performance of the ADC is evaluated by applying
a sine wave signal of very low distortion to the V
input which is sampled at a 409.6 kHz sampling rate. A Fast
Fourier Transform (FFT) plot or Histogram plot is then gener-
ated from which SNR, harmonic distortion and dynamic differ-
ential nonlinearity data can be obtained. For the DACs, the
codes for an ideal sine wave are stored in PROM and loaded
down to the DAC. The output spectrum is analyzed, using a
spectrum analyzer to evaluate SNR and harmonic distortion
performance. Similarly, for intermodulation distortion, an input
(either to VIN or DAC code) consisting of pure sine waves at
two frequencies is applied to the AD7769.
Figure 14 shows a 2048 point FFT plot of the ADC with an in-
put signal of 130 kHz. The SNR is 49.2 dB. It can be seen that
most of the harmonics are buried in the noise floor. It should be
noted that the harmonics are taken into account when calculat-
ing the SNR. The relationship between SNR and resolution (N)
is expressed by the following equation:
IN
B inputs to avoid aliasing of high frequency noise back into
SNR = (6.02N + 1.76) dB
Figure 14. ADC FFT Plot
IN
A or V
IN
A and
REV. A
IN
B