CS4365-DQZR Cirrus Logic Inc, CS4365-DQZR Datasheet - Page 41

• Manufacturer Part Number: CS4365-DQZR
• Description: IC DAC 6CH 114DB 192KHZ 48-LQFP
• Manufacturer: Cirrus Logic Inc

Specifications of CS4365-DQZR

• Number Of Bits: 24
• Data Interface: Serial
• Number Of Converters: 6
• Voltage Supply Source: Analog and Digital
• Power Dissipation (max): 390mW
• Operating Temperature: -40°C ~ 105°C
• Mounting Type: Surface Mount
• Package / Case: 48-LQFP
• For Use With: 598-1779 - EVALUATION BOARD FOR CS4365
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Settling Time: -

DS670F2
6.8.5 DSD Auto-Mute (DAMUTE)
6.8.6 MUTE Polarity and DETECT (MUTEP1:0)
6.9
6.9.1 Mute (MUTE_xx)
Reserved
0
7
Mute Control (address 09h)
Function:
When set to 1 (default), the Digital-to-Analog converter output will mute following the reception of 256 re-
peated 8-bit DSD mute patterns (as defined in the SACD specification).
A single bit not fitting the repeated mute pattern (mentioned above) will release the mute. Detection and
muting is done independently for each channel. The quiescent voltage on the output will be retained, and
the Mute Control pin will go active during the mute period.
Default = 00
00 - Auto polarity detect, selected from MUTEC1 pin
01 - Reserved
10 - Active low mute polarity
11 - Active high mute polarity
Function:
Auto mute polarity detect (00)
See
Active low mute polarity (10)
When RST is low, the outputs are high impedance and will need to be biased active. Once reset has been
released and after this bit is set, the MUTEC output pins will be active low polarity.
Active high mute polarity (11)
At reset time, the outputs are high impedance and will need to be biased active. Once reset has been
released and after this bit is set, the MUTEC output pins will be active high polarity.
Default = 0
0 - Disabled
1 - Enabled
Function:
The Digital-to-Analog converter output will mute when enabled. The quiescent voltage on the output will
be retained. The muting function is affected, similarly to attenuation changes, by the Soft and Zero Cross
bits. The MUTE pins will go active during the mute period according to the MUTEC bits.
Section 4.11 “The MUTEC Outputs” on page 29
Reserved
6
0
MUTE_B3
5
0
MUTE_A3
0
4
MUTE_B2
for description.
3
0
MUTE_A2
2
0
MUTE_B1
0
1
MUTE_A1
CS4365
0
0
41