54FCT521LMQB. National Semiconductor, 54FCT521LMQB. Datasheet - Page 3

• Manufacturer Part Number: 54FCT521LMQB.
• Manufacturer: National Semiconductor

Specifications of 54FCT521LMQB.

• Lead Free Status / RoHS Status: Not Compliant

DSCC FORM 2234
APR 97
of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the
solicitation or contract.
Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
of this drawing takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
non-JAN class level B devices and as specified herein. Product built to this drawing that is produced by a Qualified
Manufacturer Listing (QML) certified and qualified manufacturer or a manufacturer who has been granted transitional
certification to MIL-PRF-38535 may be processed as QML product in accordance with the manufacturers approved program
plan and qualifying activity approval in accordance with MIL-PRF-38535. This QML flow as documented in the Quality
Management (QM) plan may make modifications to the requirements herein. These modifications shall not affect form, fit, or
function of the device. These modifications shall not affect the PIN as described herein. A "Q" or "QML" certification mark in
accordance with MIL-PRF-38535 is required to identify when the QML flow option is used.
in MIL-PRF-38535, appendix A and herein.
as specified in table I and shall apply over the full case operating temperature range.
tests for each subgroup are described in table I.
3. REQUIREMENTS
3.1 Item requirements. The individual item requirements shall be in accordance with MIL-PRF-38535, appendix A for
3.2 Design, construction, and physical dimensions. The design, construction, and physical dimensions shall be as specified
3.2.1 Case outlines. The case outlines shall be in accordance with 1.2.2 herein.
3.2.2 Terminal connections. The terminal connections shall be as specified on figure 1.
3.2.3 Truth table. The truth table shall be as specified on figure 2.
3.2.4 Logic diagram. The logic diagram shall be as specified on figure 3.
3.2.5 Switching waveforms and test circuit. The switching waveforms and test circuit shall be as specified on figure 4.
3.4 Electrical test requirements. The electrical test requirements shall be the subgroups specified in table II. The electrical
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part
2.2 Order of precedence. In the event of a conflict between the text of this drawing and the references cited herein, the text
3.3 Electrical performance characteristics. Unless otherwise specified herein, the electrical performance characteristics are
(Copies of these documents are available online at
DEPARTMENT OF DEFENSE SPECIFICATION
DEPARTMENT OF DEFENSE STANDARDS
DEPARTMENT OF DEFENSE HANDBOOKS
MIL-PRF-38535 - Integrated Circuits, Manufacturing, General Specification for.
MIL-STD-883
MIL-STD-1835 -
MIL-HDBK-103 -
MIL-HDBK-780 -
DEFENSE SUPPLY CENTER COLUMBUS
MICROCIRCUIT DRAWING
COLUMBUS, OHIO 43218-3990
-
STANDARD
Test Method Standard Microcircuits.
Interface Standard Electronic Component Case Outlines.
List of Standard Microcircuit Drawings.
Standard Microcircuit Drawings.
httpS://assist.daps.dla.mil/quicksearch/
SIZE
A
REVISION LEVEL
or from the Standardization
D
SHEET
5962-88543
3