SI3056-D-FSR Silicon Laboratories Inc, SI3056-D-FSR Datasheet - Page 51

• Manufacturer Part Number: SI3056-D-FSR
• Description: Modem Chip Chipset 56Kbps 16-Pin SOIC T/R
• Manufacturer: Silicon Laboratories Inc

Specifications of SI3056-D-FSR

• Package: 16SOIC
• Main Category: Chipset
• Maximum Data Rate: 56 Kbps
• Typical Operating Supply Voltage: 3.3 V
• Power Supply Type: Analog
• Typical Supply Current: 15 mA
• Minimum Operating Supply Voltage: 3 V
• Maximum Operating Supply Voltage: 3.6 V
• Lead Free Status / RoHS Status: Compliant

Register 3. Interrupt Mask
Reset settings = 0000_0000
Bit
Name
Type
7
6
5
4
3
2
1
0
Bit
LCSOM
DLCSM
DODM
ROVM
RDTM
BTDM
POLM
Name
FDTM
RDTM ROVM
R/W
D7
Ring Detect Mask.
0 = A ring signal does not cause an interrupt on the AOUT/INT pin.
1 = A ring signal causes an interrupt on the AOUT/INT pin.
Receive Overload Mask.
0 = A receive overload does not cause an interrupt on the AOUT/INT pin.
1 = A receive overload causes an interrupt on the AOUT/INT pin.
Frame Detect Mask.
0 = The communications link achieving frame lock does not cause an interrupt on the AOUT/
INT pin.
1 = The communications link achieving frame lock causes an interrupt on the AOUT/INT pin.
Billing Tone Detect Mask.
0 = A detected billing tone does not cause an interrupt on the AOUT/INT pin.
1 = A detected billing tone causes an interrupt on the AOUT/INT pin.
Drop Out Detect Mask.
0 = A line supply dropout does not cause an interrupt on the AOUT/INT pin.
1 = A line supply dropout causes an interrupt on the AOUT/INT pin.
Loop Current Sense Overload Mask.
0 = An interrupt does not occur when the LCS bits are all 1s.
1 = An interrupt occurs when the LCS bits are all 1s.
Delta Loop Current Sense Mask.
0 = An interrupt does not occur when the LCS bits change.
1 = An interrupt does occur when the LCS bits change.
Polarity Reversal Detect Mask.
Generated from bit 7 of the LVS register. When this bit transitions, it indicates that the polarity
of TIP and RING was switched.
0 = A polarity change on TIP and RING does not cause an interrupt on the AOUT/INT pin.
1 = A polarity change on TIP and RING causes an interrupt on the AOUT/INT pin.
R/W
D6
FDTM
R/W
D5
BTDM DODM LCSOM DLCSM
R/W
D4
R/W
D3
Rev. 1.05
R/W
D2
Function
R/W
D1
POLM
R/W
D0
Si3018/19/10
51