CS5376A-IQZ Cirrus Logic Inc, CS5376A-IQZ Datasheet - Page 70

• Manufacturer Part Number: CS5376A-IQZ
• Description: IC,Digital Filter,QFP,64PIN,PLASTIC
• Manufacturer: Cirrus Logic Inc

Specifications of CS5376A-IQZ

• Filter Type: Digital
• Number Of Filters: 4
• Max-order: 2nd
• Voltage - Supply: 3 V ~ 5 V
• Mounting Type: Surface Mount
• Package / Case: 64-TQFP, 64-VQFP
• Package: 64TQFP
• Operating Temperature: -40 to 85 °C
• Resolution (bits): 24bit
• Conversion Rate: 4kSPS
• Operating Temperature Range: -40°C To +85°C
• No. Of Pins: 64
• Msl: MSL 3 - 168 Hours
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1778 - EVALUATION BOARD FOR CS5376
• Frequency - Cutoff Or Center: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

20.SERIAL PERIPHERAL INTERFACE 2
The Serial Peripheral Interface 2 (SPI 2) port is a
master mode SPI port designed to interface with se-
rial peripherals. By writing the SPI2 digital filter
registers, multiple serial slave devices can be con-
trolled through the CS5376A.
20.1 Pin Descriptions
CS[4:0] - Pins 32 - 36
Serial chip selects. Multiplexed with GPIO pins.
SCK2 - Pin 31
Serial clock output, common to all channels.
SO - Pin 30
Serial data output, common to all channels.
SI[4:1] - Pins 26 - 29
Serial data inputs.
20.2 SPI 2 Architecture
The SPI 2 pin interface has multiple chip selects
and serial data inputs, but a common serial clock
and serial data output. Which chip select and serial
input to use for a particular slave serial transaction
70
Digital
Filter
Figure 37. Serial Peripheral Interface 2 (SPI 2) Block Diagram
SCKFS[2:0] / SCKPO / SCKPH
SPI2EN[4:1] / RCH[1:0]
CS[4:0]
is selected by bits in the SPI2CTRL digital filter
register.
SPI 2 chip select outputs are multiplexed with
GPIO pins, which cannot perform both functions
simultaneously. When used as a chip select, the
GPIO output must be programmed high to permit
the chip select to operate as an active low signal.
See “General Purpose I/O” on page 68 for informa-
tion about programming the GPIO pins.
The SPI 2 interface transfers data from the SPI 2
registers to a slave serial device and back through a
bi-directional 8-bit shift register. Serial transac-
tions are automatic once control, command, and
data values are written into the SPI 2 digital filter
registers.
20.3 SPI 2 Registers
SPI 2 transactions are initiated by first writing
command, address, and data values to the
SPI2CMD and SPI2DAT digital filter registers,
and then writing the SPI2CTRL register to set the
D2SREQ bit. The D2SREQ bit initiates a serial
transaction using the programmed SPI2CTRL con-
figuration.
Pin logic
Select
logic
4:1
CS0
CS1
CS2
CS3
CS4
SO
SCK2
SI1
SI2
SI3
SI4
CS5376A
DS612F4