PC923L0NIP0F Sharp Microelectronics, PC923L0NIP0F Datasheet - Page 12

• Manufacturer Part Number: PC923L0NIP0F
• Description: High Speed Optocouplers Gull Wing SMT Hi Speed 15Mb/s
• Manufacturer: Sharp Microelectronics

Specifications of PC923L0NIP0F

• Isolation Voltage: 5000 Vrms
• Maximum Continuous Output Current: 100 mA
• Maximum Fall Time: 0.5 us
• Maximum Forward Diode Current: 20 mA
• Maximum Rise Time: 0.5 us
• Output Device: Integrated Photo IC
• Configuration: 1 Channel
• Maximum Baud Rate: 15 MBps
• Maximum Forward Diode Voltage: 1.75 V
• Maximum Reverse Diode Voltage: 5 V
• Maximum Power Dissipation: 550 mW
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Package / Case: PDIP-16 Gull Wing
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

■ Design Considerations
● Recommended operating conditions
● Notes about static electricity
● Design guide
Transistor of detector side in bipolar configuration may be damaged by static electricity due to its minute
design.
When handling these devices, general countermeasure against static electricity should be taken to avoid
breakdown of devices or degradation of characteristics.
In order to stabilize power supply line, we should certainly recommend to connect a by-pass capacitor of
0.01µF or more between V
In case that some sudden big noise caused by voltage variation is provided between primary and secondary
terminals of photocoupler some current caused by it is floating capacitance may be generated and result in
false operation since current may go through LED or current may change.
If the photocoupler may be used under the circumstances where noise will be generated we recommend to
use the bypass capacitors at the both ends of LED.
The detector which is used in this device, has parasitic diode between each pins and GND.
There are cases that miss operation or destruction possibly may be occurred if electric potential of any pin
becomes below GND level even for instant.
Therefore it shall be recommended to design the circuit that electric potential of any pin does not become
below GND level.
This product is not designed against irradiation and incorporates non-coherent LED.
This photocoupler is dedicated to the use for IGBT or MOSFET Gate Drive.
Please do not use this for the other application.
As mentioned below, when the input is on, if DC load (resistor etc.) is connected between O
and GND pin 7 and if the electric potential V
continuously, supply current I
Forward current
Supply voltage
Operating temperature
Parameter
Symbol
V
T
CC
I
opr
CC
F
CC
and GND near the device.
I
F
may flow more than usually and go beyond power dissipation.
MIN.
−40
10
15
2
3
TYP.
−
−
−
O2
8
5
6
7
12
goes approx. 2V below than electric potential V
A
MAX.
20
30
70
2V or more
Unit
mA
˚C
V
V
CC
PC923L0NSZ0F Series
Sheet No.: D2-A06002EN
2
output pin 6
CC
pin 8