BGA-194-194 OKI METCAL, BGA-194-194 Datasheet - Page 22

• Manufacturer Part Number: BGA-194-194
• Description: NOZZLE BGA 19.4MM X 19.4MM
• Manufacturer: OKI METCAL

Specifications of BGA-194-194

• Tip - Type: Rework
• Tip - Size: BGA, 0.76" x 0.76" (19.4mm x 19.4mm)
• Tip - Shape: Quad
• For Use With/related Products: BGA Rework Systems
• Other names: BGA194194

6. Problem: The component slide and / or prism assembly seem to be “locked up”
or restricted.
Probable Cause:
• The transportation screws are not fully loosened, resulting in the inability of the component slide and / or
Solution:
• Loosen transportation screws, which are located on the placement arm underneath the prism assembly
Probable Cause:
• The locking arm has moved during transportation to the wrong side of the lock pin.
Probable Solution:
• Remove the side cover from the placement arm and lift arm into the correct position.
7. Problem: The illumination of the component greatly outweighs the illumination of the
PCB so that an image of the component leads is not obtainable (or vise versa).
Probable Cause:
• The lighting is not adjusted correctly.
Possible Solution:
• Adjust the component illumination and PCB illumination knobs so that both images are clearly visible.
8. Problem: You are unable to slide the prism in and out of the placement arm assembly.
Probable Solution:
• The locking arm for the Z-axis control knob is on the wrong side of the prism slider pin. Remove the side
MICRO OVEN:
1. Problem: When running the BGA-S1 Software, there is an error stating that communication cannot be
Check:
• Has the BGA/CSP-3500 Control Unit been turned on?
• Is the RS232 Cable securely connected between the BGA/CSP-3500 Series Control Unit and the PC?
• Has the correct communication port been selected?
Probable Solution:
• Turn the BGA/CSP-3500 Control Unit on.
• Ensure that a firm connection has been established between the BGA/CSP-3500 Control Unit and the
• When running the BGA Software, select “Auto Detect” for communication port.
2. Problem: The Micro Oven nozzle is not mounting easily into the BGA-3528 Micro Oven Head Assembly.
Probable Cause:
• The nozzle lock / release lever has not been rotated fully counter-clockwise.
• The notch or oval hole on the Nozzle or BGA-NA Nozzle Adapter has not been indexed correctly.
20
prism assembly to move freely.
and on the top of the component slide.
cover and move the locking lever into the correct position.
established between the PC and BGA System.
PC.
BGA-3500 Series Manual 5/01