B43310A5688M000 EPCOS Inc, B43310A5688M000 Datasheet - Page 9

• Manufacturer Part Number: B43310A5688M000
• Description: CAP 6800UF 450V ELECT SCREW TERM
• Manufacturer: EPCOS Inc
• Series: B43310r

Specifications of B43310A5688M000

• Capacitance: 6800µF
• Voltage Rating: 450V
• Tolerance: ±20%
• Lifetime @ Temp.: 2000 Hrs @ 85°C
• Operating Temperature: -25°C ~ 85°C
• Features: General Purpose
• Ripple Current: 15.3A
• Esr (equivalent Series Resistance): 28.0 mOhm
• Mounting Type: Chassis Mount
• Package / Case: Radial, Can - Screw Terminals
• Size / Dimension: 3.583" Dia (91.00mm)
• Height: 6.181" (157.00mm)
• Lead Spacing: 1.248" (31.70mm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Surface Mount Land Size: -
• Other names: 495-3672; B43310A5688M

Cautions and warnings
敬告和警告
敬告和警告
Product safety
The table below summarizes the safety instructions that must be observed without fail. A detailed
description can be found in the relevant sections of Data Book 2007 – Aluminum Electrolytic
Capacitors, chapter "General technical information".
Published by EPCOS (Xiamen) Co., Ltd
厦门 EPCOS 有限公司发行
敬告和警告
敬告和警告
Topic
Polarity
Reverse voltage
Upper category temperature
Maintenance
Mounting position of screw terminal
capacitors
Mounting of single-ended
capacitors
Robustness of terminals
Soldering
Safety Information
Make sure that polar capacitors are
connected with the right polarity.
Voltages polarity classes should be
prevented by connecting a diode.
Do not exceed the upper category
temperature.
Make periodic inspections of the
capacitors.
Before the inspection, make sure
that the power supply is turned off
and carefully discharge the
electricity of the capacitors.
Do not apply any mechanical stress
to the capacitor terminals.
Do not mount the capacitor with the
terminals (safety vent) upside
down.
The internal structure of single-
ended capacitors might be
damaged if excessive force is
applied to the lead wires.
Avoid any compressive, tensile or
flexural stress.
Do not move the capacitor after
soldering to PC board.
The following maximum tightening
torques must not be exceeded
when connecting screw terminals:
M5: 2 Nm
M6: 2.5 Nm
Do not exceed the specified time or
temperature limits during soldering.
Page 9 of 13
Reference
Chapter ‘General technical
information”
1
“Basic construction of aluminum
electrolytic capacitors”
3.1.6
“reverse voltage”
7.2
“Maximum permissible operating
temperature”
10
“Maintenance”
11.1.
“Mounting positions of capacitors
with screw terminals”
11.4
“Mounting considerations for
single-ended capacitors”
11.3
“Mounting torques”
11.5
“Soldering”