Z4LC-S2840 Omron, Z4LC-S2840 Datasheet - Page 10

• Manufacturer Part Number: Z4LC-S2840
• Description: SENS NPN 28MM BEAM 40MM DIST
• Manufacturer: Omron

Specifications of Z4LC-S2840

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: Z4LCS2840

Z4LC
Precautions
The Z4LC Parallel Beam Line Sensor, is a Class 1 Laser Product
according to EN60825 (IEC825) and JIS C6802 and a Class II
Laser Product according to FDA (21 CFR1040.10) (see note).
The Z4LC is meant to be built into final system equipment. Pay
special attention to the following precautions for the safe
use of the product:
•
•
•
•
•
J LABEL INDICATIONS
10
JIS
EN
FDA
Note: Use of controls, adjustments, or procedures other than
Note: Europe: Class 1 of EN60825: 1991 = IEC825: 1984 &
Use this product as specified in this datasheet, or you may
be exposed to hazardous laser radiation.
Be careful not to expose your eyes directly to the laser radi-
ation or indirectly to laser radiation reflected from mirror or
shiny surfaces.
To avoid exposure to hazardous laser radiation, do not dis-
place nor remove the protective housing during operation,
maintenance, and any other servicing.
The user should return the product to OMRON for all repair
and servicing.
When used in other countries, observe the regulations and
standards specified by each country.
IEC825-A1: 1990
Japan: Class 1 of JIS C6802: 1991
U.S.A.: Class II of FDA (21 CFR1040.10)
those specified herein may result in hazardous radiation
exposure.
Certification and Identification Label
Class II Caution
Label Logo Type
Aperture Label
J MEASUREMENT ACCURACY
To improve the measurement accuracy, place the sensing object
as close as possible to the receiver.
J COMPATIBILITY
The Sensor or Controller can be used with another controller or
sensor. However, the emitter and receiver are adjusted as a set.
When setting up the Sensor, be sure to set the binary level
before operation.
J MAINTENANCE
Install the Sensor in clean environment and keep the filter on the
front panel of the Sensor free from oil and dust. If affected by oil
or dust, clean the filter as follows.
Use a blower brush (used to clean camera lenses) to blow large
dust particles from the surface. Do not blow the dust away with
your mouth.
Use a soft cloth (for lenses) with a little alcohol to remove the
remaining dust. Do not use a scrubbing action when cleaning as
scratches on the filter could result in a Sensor malfunction.
J ENVIRONMENT
Do not use in strong electromagnetic fields or in an environment
where the operation of the Sensor is subject to the reflection of
intensive light (such as other laser beams or electric arc welding
machine).
The Sensor may not detect the object or the resolution may be
insufficient depending on the material or shape of objects. (i.e.
transparent objects, etc.)
J MUTUAL INTERFERENCE
Sensors can be closely mounted. Do not, however, make each
laser beam closer, or the Sensors may malfunction.
J APPROPRIATE USE
The user must operate the product according to the performance
specifications described in the instruction manual.
Before using the product under conditions which are not
described in the manual or applying the product to nuclear
control systems, railroad systems, aviation systems vehicles,
combustion systems, medical equipment, amusement machines,
safety environment, and other systems, machines, and
equipment that may have a serious influence on lives and
property if used improperly, consult your OMRON representative.
Make sure that the ratings and performance characteristics of the
product are sufficient to the systems, machines, and equipment,
and be sure to provide the systems, machines, and equipment
with double safety mechanisms.
Z4LC