1804171-1 Tyco Electronics, 1804171-1 Datasheet

no-image

1804171-1

Manufacturer Part Number
1804171-1
Description
TOOL REMOVAL 2PAIR RT ANG HEADER
Manufacturer
Tyco Electronics
Datasheet
1.1804171-1.pdf (2 pages)

Specifications of 1804171-1

Lead Free Status / RoHS Status
Not applicable / Not applicable
The removal tools listed in Figure 1 are designed to
remove the housing from the chicklets of Z–PACK
HM–Zd right–angle headers. The chicklets will remain
on the printed circuit (pc) board.
Each removal tool consists of the components shown
in Figure 1. After the release block is attached to the
front of the header, the thumbscrew knob is used to
secure the puller to the housing. Rotating the lever
moves the pushers against the pc board and pulls the
housing from the header.
Before using the removal tool, each pusher must be
positioned according to the location of the header on
the pc board. Refer to Figure 2.
Adjust the pusher(s) as follows:
1. Remove the screws that secure the lever arm
(to be adjusted) onto the lever. Pull the lever arm
from the groove pin. See Figure 2.
make sure that the pushers are properly
positioned before using the removal tool.
o avoid damage to the header or pc board,
Figure 1
If adjusting both pushers, pull the other lever arm,
with the lever attached, from the groove pin.
2. Flip the pusher(s) so that either the
longer–length end (standard position, shown in
Figure 2) or shorter–length end (reversed position)
faces the front of the removal tool. For the
standard position, make sure that the indent of the
pusher faces outward. Refer to Figure 2.
3. Place the hole of the lever arm onto the groove
pin, and place the dowel pin of the lever arm into
the hole (of the pusher) closest to back of removal
tool. Refer to Figure 2.
If adjusting both pushers, do the same for the other
lever arm (with the lever attached).
4. Secure the lever arm to the lever with the
screws.
1. Loosen, but do not remove, the thumbscrew so
that the puller can be positioned at an angle. See
Figure 3, Detail A.
Figure 2

1804171-1 Summary of contents

Page 1

... Figure 1 The removal tools listed in Figure 1 are designed to remove the housing from the chicklets of Z–PACK HM–Zd right–angle headers. The chicklets will remain on the printed circuit (pc) board. Each removal tool consists of the components shown in Figure 1. After the release block is attached to the front of the header, the thumbscrew knob is used to secure the puller to the housing ...

Page 2

... Order removal tools through your representative, or call 1–800–526–5142, or send a facsimile of your purchase order to 717–986–7605, or write to: PC Board CUSTOMER SERVICE (038–035) TYCO ELECTRONICS CORPORATION PO BOX 3608 HARRISBURG PA 17105–3608 For customer repair service, call 1–800–526–5136. 7. REVISION SUMMARY ...