3442-0057 3M, 3442-0057 Datasheet

no-image

3442-0057

Manufacturer Part Number
3442-0057
Description
INSERTION PLATEN
Manufacturer
3M
Datasheet
1.3442-0057.pdf (2 pages)

Specifications of 3442-0057

Tool Type
Guide Plate, Locator
Lead Free Status / RoHS Status
Vendor undefined / Vendor undefined
Other names
05113833818
80610720635
3
3442-00XX Compliant Pin Tool
General
The 3M 3442-00XX Insertion Platen was designed to aid in
pressing compliant pin connectors onto printed circuit
boards. There is one insertion platen for each
connector position.
The platen is designed to be used with a two (2) or three (3)
ton Arbor press. The press can either be hand operated
or pneumatic.
The platen can be used with or without the latch/ejectors
in place.
PC Board Support
To protect the compliant pin during the connectors
installation, a support for the PC board is necessary.
This support should be approximately 3/4 inch thick. It can
either be drilled with the same hole pattern as the PC board,
or it could have milled grooves in a cross hatch pattern.
This support should be supplied
by the customer.
Tool Preparation
If the press has an adjustable ram, set the shut height to 1.50
± .002 inches. This would be the distance between the ram
and the top of the PC board when it is mounted on the
support block on top of the base of the press. The ram should
be fully extended at this point.
Assembly Procedure
1. Place the PC board on the designated support.
2. Place the insertion platen onto the header, making sure
3. Align the header pins with the holes in the PC board.
4. Making sure the platen and connector are directly under
Caution:
actuating ram.
5. Return ram to original position and remove the Platen
Instructions for the installation of Compliant Pin
Connectors using the 3442-00XX Insertion Platen
the header pins align with the corresponding holes in
the platen.
Slightly push to pre-seat the connector on the board.
the press ram, actuate the press ram.
from the connector.
remove hands before
3442-00XX

3442-0057 Summary of contents

Page 1

... Compliant Pin Tool Instructions for the installation of Compliant Pin Connectors using the 3442-00XX Insertion Platen General The 3M 3442-00XX Insertion Platen was designed to aid in pressing compliant pin connectors onto printed circuit boards. There is one insertion platen for each connector position. The platen is designed to be used with a two (2) or three (3) ton Arbor press ...

Page 2

... Insertion Platen Number 3442-0048 3442-0049 3442-0050 3442-0051 3442-0052 3442-0053 3442-0054 3442-0055 3442-0056 3442-0057 3442-0058 3442-0059 For technical, sales or ordering information, contact 3M at: 1-800-225-5373 Phone: 1-800-325-5329 Fax: Important Notice All statements, technical information, and recommendations related to Seller’s products are based on information believed to be reliable, but the accuracy or completeness thereof is not guaranteed ...