10983-100 3M, 10983-100 Datasheet - Page 2

• Manufacturer Part Number: 10983-100
• Description: SET-UP BLOCK
• Manufacturer: 3M

Specifications of 10983-100

• Tool Type: Set-Up Blocks
• Lead Free Status / RoHS Status: Lead free / Vendor undefined
• Other names: 90169008464; JE150170148

3
For technical, sales or order information, please contact 3M at:
Phone: [phone]
All statements, technical information and recommendations related to
the Seller’s products are based on information believed to be reliable, but
the accuracy or completeness thereof is not guaranteed. Before utilizing the
product, the user should determine the suitability of the product for
its intended use. The user assumes all risks and liability whatsoever in
connection with such use.
Any statements or recommendations of the Seller which are not contained
in the Seller’s current publications shall have no force or effect unless
contained in an agreement signed by an authorized officer of the Seller.
Electronic Products Division
6801 River Place Blvd.
Austin, TX 78726-9000
http://www.3m.com/interconnects
Lower the press handle to assemble the
connector. It is recommended to check
the tool setup before starting each
production run. Proper seating of the
connector cover onto the connector body
can be checked by measuring the height of
the connector/cover assembly.
Important Notice
Connector Assembly
Remove the protective paper lining from
the connector cover.
Fax: [phone]
4
1
7
4
Place the connector cover, then the cable
then the connector body on the locator plate.
Note: The locator plate is shown removed
from the press for clarity.
The 101XX-8000 plug may be assembled
with a strain relief that is installed on the
topside of the plug. Bend cable over the
top of the connector and snap both inside
and outside latches into the body.
Connector Body
Recycled Paper
40% Pre-consumer waste paper
10% Post-consumer waste paper
The statements contained herein are made in lieu of all warranties, expressed
or implied, including but not limited to the implied warranties of merchantability
and fitness for a particular purpose which warranties are hereby expressly
disclaimed.
SELLER SHALL NOT BE LIABLE TO THE USER OR ANY OTHER PERSON
UNDER ANY LEGAL THEORY, INCLUDING BUT NOT LIMITED TO
NEGLIGENCE OR STRICT LIABILITY, FOR ANY INJURY OR FOR ANY
DIRECT, INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES
SUSTAINED OR INCURRED BY REASON OF THE USE OF ANY OF THE
SELLER’S PRODUCTS.
Connector
Cover
Cable
2
5
5
8
When installing a plug on the end of a
cable, use the cable stopper to correctly
position the cable.
Note: The locator plate is shown removed
from the press for clarity.
Cable
Stopper
Litho in USA
© 3M 1998 34-7045-3910-4(0881.0)JHA/TG
3
6