3443-127F 3M, 3443-127F Datasheet - Page 2

• Manufacturer Part Number: 3443-127F
• Description: LOCATOR PLATE .050" SOCKET E
• Manufacturer: 3M

Specifications of 3443-127F

• Tool Type: Guide Plate, Locator
• Lead Free Status / RoHS Status: Vendor undefined / Vendor undefined
• Other names: 0-00-51111-61856-1; 00051111618561; 05111161856; 3443127F; 5111161856; 51111618561; 80-4000-1622-8; 80400016228

78-8133-3480-8-B
Assembly Press Setup
1. The appropriate 3M™ 3436-1X Shut Height
2. Place the shut height gauge on the base of the
3. Place the 3442-126 platen on the end of the press
Note: The 3M
is shown with the separately purchased 3M
Base Plate which adds stabilization to the press. Its
use is optional. The 3M
also applicable, but not shown.
Locator Plate Setup
1. Determine if you will be terminating the cable at its
2. For end terminations, place the cable stop into the
3. Place the two cover location stops into position on
4. The locator plate can now be positioned on the
Gauge was shipped with the locator plate. The
setting height is inscribed on the side of the gauge.
Select the gauge end with the same marking
selected in step one. From the chart on page one,
determine the appropriate shut height gauge
setting for the connector style and press that you
are using.
press and lightly bring down the shaft of the press
onto the surface of the shut height gauge. Adjust
the shaft length by turning the adjusting knob on
the top of the shaft (3640) or the adjusting collar
on the lower portion of the shaft of the press
(3335) so that the press handle comes completely
down with only a small amount of pressure from
the press shaft on the shut height gauge. On the
3335 only, tighten the locking collar. The shut
height distance is now set.
shaft and lock it in place by sliding the holding
clamp on the platen into the groove on the press
shaft. Your assembly press is now set up.
end or along the length of the cable (daisy-chain).
hole in the locator plate as shown. For daisy-chain
terminations, do not put the cable stop in place.
the locator plate as shown. The position toward
the outside edge is for the higher pin count
connector. The position toward the center is for
the lower pin count connector.
press base under the platen. Some operators
prefer to place the locator plate into the press after
they have prepped the cable and connector for
termination. If you prefer this method, be sure
that the cable and connector do not move when
you place the locator plate into place on the press.
™
3640 Assembly Press in the picture
™
3335 Heavy Duty Press is
™
3771
2
Cable
Location
Area
3771 Base Plate
Assembly Press Setup
Locator Plate Setup
Shut Height
Gage 3436-XX
Cable Stop
Cover
Location
stops