3443-8 3M, 3443-8 Datasheet - Page 2

• Manufacturer Part Number: 3443-8
• Description: LOCATOR PLATE .1" PCB CONNECTOR
• Manufacturer: 3M

Specifications of 3443-8

• Tool Type: Guide Plate, Locator
• Product: Tool Component
• Lead Free Status / RoHS Status: Vendor undefined / Vendor undefined
• Other names: 0-00-54007-30174-5; 00054007301745; 05400730174; 5400730174; 54007301745; 80-6051-0511-5; 80605105115

3M is a trademark of 3M Company.
Important Notice
PRODUCT USE: All statements, technical information and recommendations contained in this document are based upon tests or experience that 3M believes are reliable.
However, many factors beyond 3M’s control can affect the use and performance of a 3M product in a particular application, including the conditions under which the
product is used and the time and environmental conditions in which the product is expected to perform. Since these factors are uniquely within the user’s knowledge and
control, it is essential that the user evaluate the 3M product to determine whether it is fi t for a particular purpose and suitable for the user’s application.
Warranty; Limited Remedy; Limited Liability.
3M’s product warranty is stated in its Product Literature available upon request. 3M MAKES NO OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED
WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. If this product is defective within the warranty period stated above, your exclusive
remedy shall be, at 3M’s option, to replace or repair the 3M product or refund the purchase price of the 3M product. Except where prohibited by law, 3M will not be
liable for any indirect, special, incidental or consequential loss or damage arising from this 3M product, regardless of the legal theory asserted.

Electronic Solutions Division
Interconnect Products
6801 River Place Blvd.
Austin, TX 78726-9000
800-225-5373
www.3Mconnector.com
2.0
2.1
2.2
2.3
2.4
2.5
2.6
2.7
2.8
2.9
Assembly:
Remove the platen from the assembly press and adjust
the press shut height to the appropriate setting. (Figure 1)
Position the locator plate on the assembly press table
over the mounting studs for tight, left or front cable
entry.
Replace the platen and position it parallel with the
conductor length.
Unsoldered Connector
Soldered Connector
Grasp a plug cover strip between thumb and forefinger
of both hands, with the liner facing you. Rotate the
outermost cover down against the adjacent cover on
the strip, breaking it from the liner. Pull laterally away
from the strip. Adhesive should be present on the cover.
(Figure 2)
Firmly press ribbed side of cable into the alignment
grooves on cover. The adhesive will help it to stay in
place. Visually inspect to ensure that:
Place the connector cover and cable over the connector
body, aligning the cover holes with the cover retaining
posts. Push down firmly.
Complete the connection by lowering the assembly
press handle fully.
Visually inspect to ensure that : (Figure 3)
a. Cover is fully seated and parallel with the body.
b. Cover is properly aligned with the cable.
c. Connector is parallel with PC board.
a. Locate a connector body on the locator plate so the
a. Locate a connector body to a PC board over the
b. The connector body should be centered directly
a. Cable is properly aligned to cover grooves.
b. Cable end is flush with the cover for end
solder contacts are within the relief holes.
rubber cushion
below the assembly press shaft.
terminations or perpendicular to cover for bussing.
Please recycle. Printed in USA.
© 3M 2011
78-9100-8157-5-A
Figure 1
Figure 2
Figure 3