91293-1 Tyco Electronics, 91293-1 Datasheet - Page 3
![no-image](/images/manufacturer_photos/0/6/687/tyco_electronics_sml.jpg)
91293-1
Manufacturer Part Number
91293-1
Description
CONN COVERS LACING TERMINATION
Manufacturer
Tyco Electronics
Series
AMPMODU®r
Datasheet
1.91293-1.pdf
(4 pages)
Specifications of 91293-1
Tool Type
Cover Lacing Fixture
For Use With/related Products
Amplimite® 0.050 Series Connectors
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
4. SEATING PROCEDURE
After tooling is properly installed and secured to the
work surface, proceed as follows:
Rev
Cover Lacing Fixture 91293-1
9. Slowly lower the upper tooling assembly until it
comes in contact with the lacing fixture
subassembly. If the cutting blades strike the
stationary or adjustable locators, then move the
slide assembly until the cutting blades clear the
locators and bottom on the base of the lacing
fixture subassembly.
10. With the upper tooling assembly still lowered
onto the lacing fixture subassembly, tilt the arbor
frame assembly and tighten the slide assembly
mounting screws.
11. Return the arbor frame assembly to the correct
operating position, then carefully raise the ram and
upper tooling assembly until the upper tooling
assembly touches the frame.
12. Carefully lower the ram and upper tooling
assembly to double check that the cutting blades
clear the locators.
13. Secure the arbor frame assembly to the work
surface according to instructions supplied with the
frame assembly, or if using the bend stand
(supplied with lacing fixture), secure the bench
stand to the work surface. Remove the lacing
fixture subassembly from the slide, and place it into
the bench stand. Secure the subassembly by
tightening the thumbscrew. Refer to Figure 6.
1. Loosen the adjustable locators in each slot of
the lacing fixture subassembly base, then move
the locators so that the covers will fit into the lacing
fixture subassembly slots.
NOTE
2. Place the termination covers in their respective
slots.
3. Slide the adjustable locators toward the back of
the assembly until the locators touch the covers
and the ball plunger in each adjustable locator
sufficiently secures the covers.
4. Prepare the cable for use as described in the
instructions supplied with the connector or
termination cover.
5. Open the cable clamp by opening the latch.
Refer to Figure 7.
C
i
Due to the keying feature on the stationary
locators, the covers will only fit with the stepped
edge of the cover toward the inside of the lacing
fixture subassembly.
Tyco Electronics Corporation
Lacing Fixture
Subassembly
Latch
(Closed)
6. Place a properly prepared cable into the clamp,
with the wires protruding upward through the lacing
fixture, and with the edge of the cable jacket
approximately even with the top edge of the cable
clamp.
7. Close the latch by hooking over the pin on the
clamp.
NOTE
i
Cable
If the clamp is too tight or too loose, adjust the
clamp by moving the jaw using the setscrew
located in the back of the clamp block. Refer to
Figure 7.
Figure 6
Figure 7
Work
Surface
Thumbscrew
Socket Head
Cap Screws
Setscrew
(in Back of
Clamp Block)
Cable Clamp
Bracket
Bench
Stand
408-9750
3
of 4