10960-2000 3M, 10960-2000 Datasheet - Page 4

• Manufacturer Part Number: 10960-2000
• Description: ASSEMBLY PRESS MDR
• Manufacturer: 3M
• Series: MDRr

Specifications of 10960-2000

• Tool Type: Press, Manual
• Rohs Compliant: Yes
• Product: Tools & Accessories
• Lead Free Status / RoHS Status: Lead free / Vendor undefined
• Other names: 05113832576; 80610713978

Figure 8. Wires in “U” slot cover
Figure 10. Cut wires
5.
6.
E. Repeat for the next conductor, except position it to
0.025” Flat Ribbon Cable
A. To use the fixture unit, first remove the cable clamp
B. Slide the prepared cable end into the fixture slot so
C. Lay the conductors into the grooved wire holding slot
Pick up second cover and rub the paper liner to ensure
transfer of adhesive to the cover. Remove the paper liner
from the back of the second cover and place the cover
(adhesive side down) over the wires and first cover,
aligning it with the first cover’s guide pins. Keep the
notched end toward the operator. Press it down on
the first cover’s guide posts (Fig. 9).
Slide the platen assembly forward using the side bar
on the operator’s left side to reveal the cutting unit.
the rear and right. Place the next wire in the left slot
(adjacent to the first one), followed by another wire
in the right slot, etc., until all conductors are
in position. Proceed to Step 5.
stop (B of Fig. 6) from the fixture unit. This is done
so that the flat cable may be inserted into the
fixture unit without obstruction.
the first conductor is towards the back, facing
the left side.
accordingly until all conductors are positioned.
Proceed to Step 5.
10
8
7.
8.
9.
10. Pull the shuttle out. Placing one finger near the center
11. Push the release buttons on the front of the fixture unit to
12. Push shuttle block, with fixture unit and cable
13. Pull press handle completely down, pressing connector
14. Lift handle and pull shuttle block and assembly
15. Completed assembly may now be removed
Figure 9. 2nd cover on top of wires
Figure 11. Connector body
Push shuttle block with fixture unit and cable
subassembly away from the operator, back under
the cutting unit, until it contacts the shuttle stop.
Pull the press handle down and release, cutting
the wires (Fig. 10).
Push platen back into place using the side bar.
of the covers to prevent movement or wire dislocation,
remove the cut wires from the fixture unit.
allow placement of the connector body over the covers
(Fig. 11). Make sure the alignment tab on the inside end
of the connector body is aligned with the notch on the
second cover, nearest the operator. Push the connector
body down over the covers until a slight “click” is heard.
subassembly, away from the operator until it stops.
body onto the covers and subassembly.
toward the operator.
from the fixture unit.
4
11
9