360X30009X Conec, 360X30009X Datasheet

Manufacturer Part Number

360X30009X

Description

KEYING TOOL FOR 165X HOODS

Manufacturer

Conec

Datasheet

1.165X14839XE.pdf (1 pages)

Tool Type

Insertion Tool

Product

Tools & Accessories

Accessory Type

Insert Tool

Ip Rating

IP67

For Use With/related Products

D-Sub Connectors

Lead Free Status / RoHS Status

Not applicable / Not applicable

Other names

626-1322

Installation Procedure For Resistant Hoods

Assembly steps:

1. Hold connector shell in the position shown on the picture. The holes of the shell have to be placed over the screws in the

hood. Attention: Do not push the shell further into the hood to avoid damaging the detent latches in the hood.

2. Place the assembly key between the connector shell and the hood over the detent latch. Gently pry open the hood while

pushing the connector down into the slot behind the detent latch. Remove the assembly key.

3. Verify that the shell is positioned behind the detent latch on one side of the hood. Place the assembly key between the

opposite side of the connector shell and the hood over the detent latch. Gently pry open the hood while pushing the connector

down into the slot behind the detent latch.

4. Remove the assembly key. Verify that the shell is placed in both slots behind the detent latches.