91419-1 Tyco Electronics, 91419-1 Datasheet

no-image

91419-1

Manufacturer Part Number
91419-1
Description
INSERTION TOOL / BAND POST
Manufacturer
Tyco Electronics
Datasheet
1.91419-1.pdf (2 pages)

Specifications of 91419-1

Lead Free Status / RoHS Status
Not applicable / Not applicable
PROPER USE GUIDELINES
1. INTRODUCTION
This instruction sheet covers the use of Uninsulated
Bandolier Post Insertion Tool 91419–1 which are
designed to insert the loose–piece version of
AMPMODU* .025 Square Post with Bandolier Carrier
Strip onto printed circuit (pc) boards or panels. This
insertion tool is used with posts having a mating
length ranging from 5.97–11.43 [.235–.450]. See
Figure 1. Read these instructions carefully before
using the tool.
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
2. DESCRIPTION
The insertion tool consist of a spring–loaded plunger
and a receptacle tip which forces the uninsulated
posts into the pc board. The tip features an adjusting
nut and a locknut which allows adjustment for various
post lengths. In order to activate the impact
mechanism, 53.38–57.83 N [12–13 lb–force] is
required.
A pc board (or panel) support should be used during
insertion. Make certain that the support is deep
enough to receive the fully inserted posts.
E
NOTE
Dimensions in these instructions are in metric
units [with inches in brackets]. Figures are for
reference only and are not drawn to scale.
Uninsulated Bandolier Post
Insertion Tool 91419-1
Insertion Tool 91419-1
Figure 1
3. INSERTION PROCEDURE
DANGER
1. Check the mating length of the post, then adjust
the tip insertion depth as follows:
(a) Loosen the locknut and rotate the
adjustment nut (see Figure 1) until the proper
insertion depth is achieved. Use the formula
given in Figure 2 as a guide.
(b) When the proper insertion depth is
achieved, retighten the locknut against the
adjustment nut.
Do NOT depress the tool handle when the tool is
not being used to insert a post. Doing so may
cause injury or damage to the tool.
Figure 2
www.tycoelectronics.com
408-6944
1

91419-1 Summary of contents

Page 1

... Make certain that the support is deep enough to receive the fully inserted posts. E Uninsulated Bandolier Post Insertion Tool 91419-1 Insertion Tool 91419-1 Figure 1 Do NOT depress the tool handle when the tool is DANGER not being used to insert a post. Doing so may cause injury or damage to the tool. ...

Page 2

... Release the handle, allowing the handle to retract. The post is fully inserted when the tool tip bottoms on the pc board. CUSTOMER REPLACEABLE PARTS FOR UNINSULATED BANDOLIER POST INSERTION TOOL 91419-1 ITEM NO. PART NUMBER 2 ...