791804-2 Tyco Electronics, 791804-2 Datasheet - Page 6

• Manufacturer Part Number: 791804-2
• Description: TOOL TERMINATING MODULE 26-24AWG
• Manufacturer: Tyco Electronics

Specifications of 791804-2

• Lead Free Status / RoHS Status: Not applicable / Not applicable

Terminating Modules 791804-[ ]
6
1:1 and 1:N
Crossed
Conductors
CAUTION
ORIENTATION
of 7
!
Failure to perform periodic inspection and
cleaning can cause the module to make defective
modular plug terminations leading to
discontinuities on individual wire circuits.
The tester checks for open
conductors.
If there are no open conductors,
the tester checks for short
circuits.
No opens" or shorts" are
found.
With the position selector switch
in the LEARN position, the tester
compares the cable assembly
against a learned" cable
pattern. When a cable assembly
has a learned" cable pattern,
open conductors, as well as
crossed conductors, are noted.
If there are no connections
where there should be opens,
the tester will conduct the
opens" test.
If there are no opens present the
tester performs the shorts" test.
The cable assembly passes all
three tests
.
TEST
One or more open conductors.
The cable assembly has two or
more shorted conductors.
The cable assembly is
considered good.
Contacts that were learned as
open" are found to have
continuity to other conductors in
the cable assembly.
The cable assembly has one or
more open conductors
The cable assembly has two or
more shorted conductors.
The cable assembly is
considered good.
Tyco Electronics Corporation
TESTING SUMMARY
CONDITION
Figure 6
6. TROUBLESHOOTING
For solutions to problems not mentioned in Figure 7,
call the TOOLING ASSISTANCE CENTER at the
number at the bottom of page 1.
.
A
light. The Wire Position LEDs will also light,
corresponding to the open conductors of the
modular plug located in the right-hand nest.
Note:
A
light. The Wire Position LEDs will also light,
corresponding to the shorted conductors of the
modular plug located in the right-hand nest.
The tester will sound a
GOOD LED will light.
The tester will sound a
OPEN and SHORT LEDs, and light the Wire
Position LEDs corresponding to the connected
conductors of the modular plug located in the
right-hand side of the nest
The tester will sound a
LED will light, and the Wire Position LEDs will
light, corresponding to the open conductors of
the modular plug located in the right-hand side
of the nest.
The tester will sound a
LED will light, and the Wire Position LEDs will
light, corresponding to the open conductors of
the modular plug located in the right-hand side
of the nest.
The tester will sound a
GOOD LED will light.
long
long
If opens" are found, the tester abandons
further testing, therefore shorts that may
have also been present will not be
indicated.
tone will sound and the OPEN LED will
tone will sound and the SHORT LED will
TEST INDICATORS
short
long
long
long
short
.
tone, light both the
tone, the OPEN
tone, the SHORT
tone and the
tone and the
408-8734
Rev
C