68201-1 Tyco Electronics, 68201-1 Datasheet - Page 2

• Manufacturer Part Number: 68201-1
• Description: TOOL DIE SET ASSEMBLY 2/0AWG
• Manufacturer: Tyco Electronics

Specifications of 68201-1

• Lead Free Status / RoHS Status: Not applicable / Not applicable

1. Select the proper size terminals and die set for
the wire size being used. See Figure 2.
2. Strip the wire to the dimensions indicated in
Figure 2.
1. Ensure the wire size stamped on the terminal
corresponds with the wire size stamped on the
dies.
2. Orient the 1/0 terminal with the dies so the large
slot in the terminal is rotated 30 to 60 from the
vertical as shown in Figure 3A. Orient the 250
MCM and 350 MCM terminals with the dies so that
the large slot in the terminals is rotated 45 from
the vertical as shown in Figure 3A.
3. Position the terminals so the dies are centered
on the wire barrels of the terminals as shown in
Figure 3A.
4. Activate the power unit so the moving die
advances and holds the terminal in place. Do NOT
deform the terminal.
5. Insert a stripped wire all the way into the
terminal wire barrel. Activate the power unit to
complete the crimp.
6. Refer to Section 3 and Figure 5 for crimp
inspection.
!
Avoid personal injury. When operating power unit,
exercise caution while holding terminals or wire
near crimping area.
Do NOT nick or cut conductor strands.
Figure 2
A
1/0
B
400 MCM
Figure 3