69930 Tyco Electronics, 69930 Datasheet - Page 5

• Manufacturer Part Number: 69930
• Description: DIE W-DG 68075 69875 22-16AWG
• Manufacturer: Tyco Electronics

Specifications of 69930

• Lead Free Status / RoHS Status: Not applicable / Not applicable

4.4. Replacement Parts
Customer–replaceable parts are listed in Figure 7. A
complete inventory should be stocked and controlled
to prevent lost time when replacement of parts is
necessary. Order replacement parts through your
representative, or call 1–800–526–5142, or send a
facsimile of your purchase order to 717–986–7605, or
write to:
Rev
AMP-TAPEMATIC Crimping Dies
If you find that the crimp die closures do not
conform with the GO NO–GO gage conditions,
contact your local Tyco Electronics Representative.
B
A" - Inspection of Wire Barrel Crimp Dies
NO-GO" Gage May Enter
Tyco Electronics Corporation
Pass Completely Through
Wire Barrel Dies are
Bottomed but Not
Under Pressure
GO" Gage Must Pass
Partially, but Must Not
Completely Through
the Die Closure
the Die Closure
Figure 6
5. REVISION SUMMARY
This paragraph is reserved for a revision summary of
changes and additions made to this document. The
following changes were made for this revision.
Insulation
Crimping Dies
CUSTOMER SERVICE (038–035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105–3608
S Updated document to corporate requirements
S New format
B" - Inspection of Insulation Crimp Dies
Wire Barrel
Crimp Dies
1.181 [.0465]
Gage Dim.
408-2648
5
of 6