679304-1 Tyco Electronics, 679304-1 Datasheet - Page 3

• Manufacturer Part Number: 679304-1
• Description: TOOL PNEUMATIC HEAD ASSEMBLY
• Manufacturer: Tyco Electronics

Specifications of 679304-1

• For Use With: 6-26 Series Pneumatic Tool System
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Lead Free Status / RoHS Status: na, Not applicable / Not applicable

The pneumatic tooling assembly is now ready to be
used.
3.2. Removal
Rev C
Pneumatic Head Assembly 679304-1
DANGER
3. Connect tool to an adequate air supply between
620–690 kPa [90–100 psi]. For specific information
on air line requirements and air hose installation,
refer to the instructions packaged with the
pneumatic tooling assembly.
1. Remove quick pins.
2. Remove head assembly from tool holder.
Disconnect pneumatic tooling assembly from air
supply before removing crimping head.
Tyco Electronics Corporation
Figure 3
4. CRIMPING PROCEDURES
The crimping procedures which follow are basic.
Refer to the instruction sheet packaged with the die
assembly for details.
DANGER
1. Strip wire using the recommended strip–length
dimensions. Refer to instruction sheet supplied
with the die assembly.
2. Open crimping jaws by squeezing the rollers
together; then position the connector into the
appropriate crimping chamber.
3. After connector is properly positioned in the
dies, release rollers to allow the jaws to spring
shut, securing the connector within the dies.
4. Insert stripped wire into connector.
ALWAYS keep fingers clear of head assembly
jaws when operating the pneumatic tooling
assembly.
408-4070
3 of 5