679301-1 Tyco Electronics, 679301-1 Datasheet - Page 5

• Manufacturer Part Number: 679301-1
• Description: TOOL 22-10AWG SOLIS CRIMP HEAD
• Manufacturer: Tyco Electronics

Specifications of 679301-1

• Lead Free Status / RoHS Status: Not applicable / Not applicable

Regular inspections should be performed by quality
control personnel. A record of scheduled inspections
should remain with the crimping heads or be supplied
to supervisory personnel responsible for the crimping
heads. Though recommendations call for at least one
inspection a month, the frequency should be based
on amount of use, working conditions, operator
training and skill, and your established company
policies. These inspections should include a visual
inspection (Paragraph 6.3 and a crimping chamber
inspection (Paragraph 6.5).
Rev
{
Trademark of Dow Corning Corporation
1. Remove all lubrication and accumulated film by
immersing the crimping head in a suitable
commercial degreaser that will not affect paint or
plastic.
2. Make certain all components are in place. If
replacements are necessary, refer to Figure 9.
3. Check all bearing surfaces for wear. Make sure
the rollers turn freely with minimal resistance.
Replace any worn parts.
4. Inspect the crimp area for flattened, chipped, or
broken areas. Although the crimping chambers
may gage within permissible limits, worn or
damaged die closure surfaces are objectionable
and will affect the quality of the crimp.
1338757-1
1338758-1
679301-1
16-14HD / 12-10
679301-1
GO Dimension
22-16
16-14
8
6
1.168-1.176 [.0460]-.0463]
1.371-.1.379 [.0540-.0543]
1.930-1.938 [.0760-.0763]
2.54 -2.547 [.1000-.1003]
3.149-3.157 [.1240-.1243]
All Heads 6.35 [.250] Min. Typ.
Tyco Electronics Corporation
Die Closure Configuration
25.4 [1.00]
1338757-1
Figure 7
Min. Typ.
Lubricate all pins, pivot points, and bearing surfaces
with a high quality grease. Tyco Electronics
recommends the use of Molykote
commercially available lubricant. Lubricate according
to the following schedule:
Wipe excess grease from crimping head, particularly
from die closure areas. Grease transferred from the
die closure area onto certain terminations may affect
the electrical characteristics of a termination.
This inspection requires the use of plug gages
conforming to the dimensions shown in Figure 7. Tyco
Electronics does not manufacture or market these
gages.
Head used in daily production – lubricate daily
Head used daily (occasional) – lubricate weekly
Head used weekly – lubricate monthly
1. Remove oil and dirt from the bottom of the jaw
surfaces, and plug gage element surfaces.
2. Close the crimping jaws until they are bottomed,
but not under pressure.
1.318-1.320 [.0519-.0520]
1.521-1.524 [.0599-.0600]
2.080-2.082 [.0819-.0820]
2.690-2.692 [.1059-.1060]
3.299-3.302 [.1299-.1300]
To avoid personal injury, disconnect air supply
and remove crimping head from tool before
inspecting the crimping chambers.
NO-GO Dimension
R"
1338758-1
{
paste, which is a
1.57 [.062]
1.57 [.062]
2.36 [.093]
3.58 [.141]
3.96 [.156]
of 7