1490407-2 Tyco Electronics, 1490407-2 Datasheet - Page 6

• Manufacturer Part Number: 1490407-2
• Description: INDENTER U-DIE TERMINYL #4
• Manufacturer: Tyco Electronics

Specifications of 1490407-2

• Lead Free Status / RoHS Status: Not applicable / Not applicable

If the crimping chamber conforms to the gage
inspection, the crimping die is considered
dimensionally correct and should be lubricated with a
THIN coat of SAE 20 motor oil. If not, the dies must
be repaired before returning them to service (see
Section 7, REPLACEMENT AND REPAIR).
6
Crimping Die Assemblies
Die Closure Configuration
of 7
1. Mate the dies until it is evident that they have
bottomed. Hold the dies in this position.
2. Align the GO element with the crimping
chamber. Push element straight into the crimping
chamber without using force. The GO element
must pass completely through the crimping
chamber as shown in Figure 9.
3. Align the NO–GO element and try to insert it
straight into the crimping chamber. The NO–GO
element may start entry but must not pass
completely through as shown in Figure 9.
CRIMPING DIE
CRIMPING DIE
1490597-1
1490598-1
1490599-1
1490406-1
1490700-1
GO Diameter
Suggested Plug Gage Design
10.185-10.193
[.2010-.2013]
[.2370-.2373]
[.2690-.2693]
[.3190-.3193]
[.4010-.4013]
5.105-5.113
6.020-6.027
6.833-6.840
8.103-8.110
Figure 8
GAGE ELEMENT DIAMETER
GO
NO-GO Diameter
25.4 [1.00]
(Min Typ)
10.335-10.338
[.2069-.2070]
[.2429-.2430]
[.2749-.2750]
[.3249-.3250]
[.4069-.4070]
5.255-5.258
6.170-6.172
6.982-6.985
8.252-8.255
NO-GO
Tyco Electronics Corporation
For additional information concerning the use of a
plug gage, refer to instruction sheet 408–7424.
7. REPLACEMENT AND REPAIR
The parts listed in Figure 10 are customer–
replaceable. A complete inventory can be stocked
and controlled to prevent lost time when replacement
of parts is necessary. Order replacement parts
through your Tyco Electronics Representative, or call
1–800–526–5142, or send a facsimile of your
purchase order to 1–717–986–7605, or write to:
Dies may be returned for evaluation and repair. For
die repair service, contact a representative at
1–800–526–5136.
8. REVISION SUMMARY
GO element must pass
completely through the
crimping chamber.
CUSTOMER SERVICE (38–35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105–3608
S Updated document to corporate requirements
S Added new part number to table in Figure 1
Crimping
Chamber
GO
Element
Crimping
Chamber
Figure 9
NO-GO element may enter
partially, but must not pass
completely through the
crimping chamber.
NO-GO
Element
Plug Gage
408-8704
Rev
A