1055781-1 Tyco Electronics, 1055781-1 Datasheet - Page 2

• Manufacturer Part Number: 1055781-1
• Description: TOOL HEX DIE SET A, B, C
• Manufacturer: Tyco Electronics

Specifications of 1055781-1

• Crimp Or Cable Size: 55B. 58C, 141A, 142B,174, 174B, 178B, 187A, 188A, 196A, 223, 303, 316, 400
• Product: Tool Component
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Connector Type: -
• Crimp Handle: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Center
Contact
Holder
Inner
Conductor
2
SSMA Bulkhead Feedthrough Jack Connector (Crimp Attachment) 1045506-1
of 2
4. Tin the inner conductor.
5. Position and secure the inner sleeve in a bench
vise.
firmly.
7. Slide the outer sleeve over the flared cable
braid.
8. Hold the cably firmly and crimp the outer sleeve
to the braid using 2.67 [.105] hex die cavity. See
Figure 4.
9. Trim the excess cable braid.
10. Place the center contact in the center contact
holder (Figure 2) and heat the center contact.
11. Push the center contact over the inner
conductor of the cable. See Figure 5.
NOTE
12. Remove excess solder.
6. Insert the cable into the inner sleeve and seat it
Heat Here
i
Dielectric
The large diameter of the contact should rest
firmly against the dielectric.
1.016
[.040]
Dielectric
Inner Sleeve
Center Contact
Figure 4
Figure 5
Crimp Tool
Outer
Sleeve
Tyco Electronics Corporation
Sheath
4. REVISION SUMMARY
Since the previous release of this sheet:
Reference Plane
13. Assemble the dielectric over the center
contact.
14. Engage the threads of the inner sleeve to the
housing and torque to 25–30 in. lbs.
15. Position the outer sheath over the outer sleeve
as shown in Figure 6.
16. Shrink the sheath with a heat gun, using
indirect heat.
17. Adherence to the preeding steps should yield
the tolerances shown in Figure 7.
S Document format was updated to current
corporate requirements.
Housing
Inner Sleeve
Figure 6
Figure 7
0.00-0.25 [.000-.010]
Contact
Sheath
0.00-0.18 [.000-.007]
Dielectrric
408-4785
Rev
A