69735 Tyco Electronics, 69735 Datasheet - Page 2

• Manufacturer Part Number: 69735
• Description: DIE PIDG STRATO 69710 12-10AWG
• Manufacturer: Tyco Electronics

Specifications of 69735

• Lead Free Status / RoHS Status: Not applicable / Not applicable

3.2. Application Tooling
Power for seating tools must be provided by a
machine capable of supplying a downward force of
45 Newtons (N) [10 lb] per contact.
4. SEATING
2
Seating Tools 91348-[ ], 91349-[ ], and 91375-[ ]
CAUTION
1. Set seating height to the dimension shown in
Figure 2 (application tool shut height will equal the
tool seating height PLUS the combined
thicknesses of the pc board and support fixture).
After seating, a gap of no more than 0.254
[.010] between the connector standoffs and the pc
board is allowed.
2. Position the connector on the pc board so that
contacts are properly aligned with the holes in the
pc board and pc board support fixture.
3. Sit the connector onto pc board until the open
section of the contacts are resting securely on, but
have not fully entered, the holes in the pc board.
4. Orient the key(s) of the blade with the groove(s)
on the inside of the connector housing, then
position the seating tool onto the connector,
making sure the blade bottoms on the housing
floor.
!
Note:
Over-driving of the connector will deform parts
critical to the quality of the connection. Maximum
force occurs prior to the connector bottoming on
the pc board.
Figure 2
5. MAINTENANCE AND INSPECTION
5.1. Daily Maintenance
It is recommended that each operator be made aware
of, and responsible for, the following steps of daily
maintenance:
CAUTION
5. Center the seating tool (with the connector)
under the ram of the applicator tool; and slowly
lower the ram until it just meets the seating tool.
Verify alignment of the pc board support fixture, pc
board, connector, and seating tool.
6. Cycle the ram according to instructions included
with the application tooling. Check the connector
for proper seating using the requirements in
Application Specification 114–13059.
7. Remove the pc board or reposition the pc board
and pc board support fixture for seating additional
connectors.
1. Remove dust, moisture, and other contaminants
with a clean, soft brush, or lint–free cloth. DO NOT
use objects that could damage the tool or any of its
components.
!
Damage to the pc board, seating tool, or
connector may occur if the wrong seating tool is
used, if the seating height is improperly set, or if
the seating tool is not properly seated in the
connector before cycling the ram. DO NOT use
damaged product.
408-8501
F