58517-4 Tyco Electronics, 58517-4 Datasheet - Page 2

• Manufacturer Part Number: 58517-4
• Description: TOOL PRO-CRIMPER II DIE SET
• Manufacturer: Tyco Electronics

Specifications of 58517-4

• Lead Free Status / RoHS Status: Not applicable / Not applicable

2. DESCRIPTION
The tool features a tool frame with a stationary jaw
and handle, a moving jaw, a moving handle, and an
adjustable ratchet that ensures full contact crimping.
The tool frame holds a die assembly with one
crimping section.
The die assembly features a wire anvil, an insulation
anvil, a wire crimper, and an insulation crimper.
Attached to the outside of the frame is a locator,
which holds and helps to position the contact.
Die retaining pins and die retaining screws are used
to position and secure the dies in the tool frame. A
washer and nut is used on the lower die retaining
screw to hold the locator in place.
3. INSTALLATION AND REMOVAL OF DIE SET
2
PRO-CRIMPER III Hand Crimping Tool Assembly 58517-[ ]
of 4
AND LOCATOR ASSEMBLY
1. Open the tool handles and remove the two die
retaining screws from the tool jaws.
2. Place the wire anvil and insulation anvil in the
moving jaw so that their chamfered sides and their
marked surfaces face outward, when mounted in
the moving jaw of the tool frame.
3. Insert the two die retaining pins.
4. Insert the long die retaining screw through the
jaw and through both anvil dies, and tighten the
Wire Crimper
Chamfer
Offset
Nut
Washer
Wire Anvil
(Figures 1 and 2)
Locator
(Figure 2)
Adjustment
Screw
Insulation
Crimper
Tyco Electronics Corporation
Chamfer
Nut
Figure 2
Insulation
Anvil
screw just enough to hold the dies in place. Do not
tighten the screw completely at this time.
5. Place the wire crimper and insulation crimper in
the stationary jaw so that their chamfered sides
and their marked surfaces face outward, when
mounted in the stationary jaw of the tool frame.
6. Insert the two die retaining pins.
7. Insert the short die retaining screw through the
jaw and through both crimper dies, and tighten the
screw just enough to hold the dies in place. Do not
tighten the screw completely at this time.
8. Carefully close the tool handles, making sure
that the anvils and crimpers align properly.
Continue closing the tool handles until the ratchet
in the tool frame has engaged sufficiently to hold
the anvils and crimpers in place, then tighten both
die retaining screws.
9. Place the locator over the end of the long screw,
and position the locator against the side of the tool
jaw.
10. Place the washer and nut onto the end of the
long screw. Align the locator slot with the crimping
section and carefully tighten the nut.
11. To disassemble, close the tool handles until the
ratchet releases, remove the nut, the washer, the
locator, the two die retaining screws, and the four
die retaining pins, and slide the anvils and crimpers
out of the tool jaws.
Die Retaining
Screws
Tool Frame
Die Retaining
Pins
408-4064
Rev
C