58517-2 Tyco Electronics, 58517-2 Datasheet - Page 3
![DIE SET CST-100](/photos/9/90/99025/58517-2_sml.jpg)
58517-2
Manufacturer Part Number
58517-2
Description
DIE SET CST-100
Manufacturer
Tyco Electronics
Series
Pro-Crimper III, CST-100r
Type
Hand Tool Assemblyr
Specifications of 58517-2
Connector Type
Crimp Terminals
Crimp Handle
A9996-ND
Crimp Or Cable Size
22-26 AWG
Rohs Compliant
NA
Product
Crimping, Stripping & Cutting Tools & Drills
Lead Free Status / RoHS Status
Not applicable / Not applicable
Lead Free Status / RoHS Status
Not applicable / Not applicable
Other names
A19531
4. CRIMPING PROCEDURE
Refer to the table in Figure 1 and select wire of the
specified size and insulation diameter. Strip the wire
to the length indicated in Figure 1, taking care not to
nick or cut wire strands. Select an applicable contact
and identify the appropriate die assembly according to
the wire size markings on the die. Refer to Figure 3
and proceed as follows:
PRO-CRIMPER III Hand Crimping Tool Assembly 58517-[ ]
CAUTION
NOTE
1. Hold the tool so that the back (wire side) is
facing you. Squeeze tool handles together and
allow them to open fully.
2. Holding the contact by the insulation barrel,
insert the contact — mating end first — into the
locator slot. Position the contact so that the open
“U” of the wire and insulation barrels face the top of
the tool. Make sure the contact butts against the
adjustment screw. Check that the contact is
centered with the die assembly wire and insulation
anvils. If adjustment is required, refer to Section 5,
CONTACT SUPPORT ADJUSTMENT.
C
i
!
This tool is provided with a crimp adjustment
feature. Initially, the crimp height should be
verified as specified in Figure 4. Refer to
Section 6, CRIMP HEIGHT INSPECTION, and
Section 7, CRIMP HEIGHT ADJUSTMENT, to
verify crimp height before using the tool to crimp
desired contacts and wire sizes.
Make sure that both sides of the insulation barrel
are started evenly into the crimping section. Do
NOT attempt to crimp an improperly positioned
contact.
Figure 3
5. CONTACT SUPPORT ADJUSTMENT
3. Hold the contact in position and squeeze the
tool handles together until ratchet engages
sufficiently to hold the contact in position. Do NOT
deform insulation barrel or wire barrel.
NOTE
4. Insert stripped wire into contact insulation and
wire barrels until it is butted against the wire stop
on the contact, as shown in Figure 3.
5. Holding the wire in place, squeeze tool handles
together until ratchet releases. Allow tool handles
to open and remove crimped contact.
6. Check the contact’s crimp height as described in
Section 6, CRIMP HEIGHT INSPECTION. If
necessary, adjust the crimp height as described in
Section 7, CRIMP HEIGHT ADJUSTMENT.
1. Make a sample crimp according to Section 4,
CRIMPING PROCEDURE. If the crimp is out of
alignment, adjustment is required.
2. To move the contact from side–to–side, loosen
the nut that holds the locator to the frame and slide
the locator until the contact is properly positioned.
Hold the locator in place and tighten the nut.
3. To move the contact in or out, loosen the nut on
the adjustment screw and turn the screw until the
contact is properly positioned. Hold the screw in
place and tighten the nut.
i
The ratchet has detents that create audible clicks
as the tool handles are closed.
Tool No.
Dim ``A"
408-4064
3