58545-1 Tyco Electronics, 58545-1 Datasheet - Page 3
![DIE SET UNINSULATED TERMINALS](/photos/9/89/98992/58545-1_sml.jpg)
58545-1
Manufacturer Part Number
58545-1
Description
DIE SET UNINSULATED TERMINALS
Manufacturer
Tyco Electronics
Series
Pro-Crimper™ III, Solistrand™r
Specifications of 58545-1
Connector Type
Terminals and Splices
Crimp Handle
A9996-ND
Crimp Or Cable Size
10-22 AWG
Wire Size (awg)
22-10
For Use With
SOLISTRAND Uninsulated Terminals And Splices
Lead Free Status / RoHS Status
Not applicable / Not applicable
Other names
A9813
Rev D
6. To crimp the other half of a splice, reposition the
uncrimped wire barrel in the crimping chamber, and
repeat the crimping procedure.
NOTE
If splice cannot be turned for crimping the other
half, turn the tool around.
2
Splice Wire Barrel
Centered on Anvil of
Lower Die
4
Inspection Hole
3
Brazed Seam
Positioned Toward
Indenter
PRO–CRIMPER II Hand Tool Assembly 58546–1
1
3
Figure 3
Figure 4
CAUTION
1
2
3
4
7. Inspect the crimped splice according to
Figure 4. Check the crimp height as described in
Section 5. If necessary, adjust the shut height as
described in Section 6.
Crimp is centered on wire barrel. It is acceptable for
crimp to be slightly off center, but NOT OFF THE END of
the wire barrel.
Wire size being used matches wire size range stamped
on splice and dies.
Wire insulation does not enter wire barrel.
Wire is flush with or extends slightly beyond end of wire
barrel. Wire is visible through inspection hole of splices.
Damaged splices may not be used. If a damaged
splice is evident, it must be replaced with a new
one.
408–4047
3 of 5