1213860-1 Tyco Electronics, 1213860-1 Datasheet - Page 2

• Manufacturer Part Number: 1213860-1
• Description: CERTI-CRIMP II ADAPT-SDE BENCH
• Manufacturer: Tyco Electronics
• Series: Certi-Crimp™r

Specifications of 1213860-1

• Accessory Type: Handle
• Tool Type: Tool Holder Assembly
• For Use With/related Products: SDE Electric Bench Terminator
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Features: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

The two outer quick–release pins secure the outer
tabs of the crimping head to the tool holder assembly,
and the center quick–release pin secures the the
movable die of the crimping head to the internal
spring–loaded switch of the tool holder assembly.
3. INSTALLATION AND REMOVAL
3.1. Installation and Removal of the CERTI-CRIMP II
Tool Holder Assembly 1213860-1
A. Installation
Before mounting the CERTI–CRIMP II Tool Holder
Assembly, always make sure the guide ram of the
terminator is in the lowest position. See Figure 3.
2
DANGER
of 5
1. Be sure that the terminator has been switched
off.
2. Be sure that the CERTI–CRIMP II tool holder
assembly is mounted with the switch (handle) in
the front, to facilitate die opening and closing.
3. Mount the tool holder assembly from the back
and lock with the guide (safety) pins. Refer to
Figure 3 and Figure 4.
4. Refer to Paragraph 3.2, to remove and install
the crimping dies.
Housing Center
Quick-Release Pin
Quick-Release Pin
To avoid personal injury, be sure the SDE Electric
Bench Terminator is disconnected from the power
source prior to the installation or removal of the
tool holder assembly.
Housing
Side
CERTI-CRIMP II Tool Holder Assembly 1213860-1
Figure 2
B. Removal
3.2. Installation and Removal of CERTI-CRIMP II
Crimping Heads
DANGER
DANGER
1. Be sure the terminator has been switched “off.”
2. Remove the locating pins from the tool holder
assembly.
3. Remove and/or replace the tool holder
assembly.
4. When removing the tool holder assembly, make
sure that the guide ram of the terminator is in the
lowest position.
5. If installing or removing crimping dies, refer to
Paragraph 3.2.
To avoid personal injury, be sure the SDE Electric
Bench Terminator is disconnected from the power
source prior to the installation or removal of the
tool holder assembly.
To avoid personal injury, be sure the SDE Electric
Bench Terminator is disconnected from the power
source prior to the installation or removal of the
crimping heads.
Housing
Side
Housing Center
Switch (Handle)
408-10021
Rev
A