576782 Tyco Electronics, 576782 Datasheet - Page 6

• Manufacturer Part Number: 576782
• Description: TOOL HAND HVY HD STRATO 14AWG
• Manufacturer: Tyco Electronics

Specifications of 576782

• For Use With/related Products: 14 AWG
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Features: -
• Tool Type: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

D. CERTI-CRIMP Hand Crimping Tool Ratchet
Control Inspection
The CERTI–CRIMP hand crimping tool ratchet control
feature on Tyco Electronics hand tools should be
checked to ensure that the ratchet does not release
prematurely, allowing the dies to open before they
have fully bottomed. Obtain a 0.025 mm [.001 in.]
shim that is suitable for checking the clearance
between the bottoming surfaces of the crimping dies.
Proceed as follows:
6 of 7
PIDG STRATO-THERM Terminal Crimping Tools
1. Select the maximum size wire for the tool and a
terminal.
2. Position the terminal and wire between the
crimping dies as described in Section 3.
3. Hold wire in place and squeeze tool handles
until the CERTI–CRIMP hand crimping tool ratchet
control releases. Hold the handles in this position,
maintaining just enough tension to keep the dies
closed.
4. Check the clearance between the bottoming
surfaces of the crimping dies with the 0.025 mm
[.001 in.] shim. If the clearance is 0.025 mm
[.001 in.] or less, the ratchet is considered
Tyco Electronics Corporation
7. REPLACEMENT AND REPAIR
Replaceable parts are listed in Figure 7. Parts other
than those listed in Figure 7 should be replaced by
Tyco Electronics to ensure quality and reliability of the
tool. Order replacement parts through your Tyco
Electronics Representative, or call 1–800–526–5142,
or send a facsimile of your purchase order to
1–717–986–7605, or write to:
For tool repair service, please contact an Tyco
Electronics Representative at 1–800–526–5136.
8. REVISION SUMMARY
satisfactory. If the clearance exceeds 0.025 mm
[.001 in.], the ratchet is out of adjustment and must
be repaired.
CUSTOMER SERVICE (38–35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105–3608
S Updated document to corporate requirements
S Changed item 6 part number in table in
Figure 7
408-10040
Rev C