PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- - use, production operations is available.
1. INTRODUCTION
PRO--CRIMPER III Hand Crimping Tool Assembly
58433--3 consists of PRO--CRIMPER III Hand
Crimping Tool Frame 354940--1 and Die Assembly
58423--1. The tool assembly is used to crimp the
terminals listed in Figure 1 . For additional information
on the hand tool frame, refer to 408--9930. Read
these instructions thoroughly before using the tool
assembly.
Reasons for reissue of this instruction sheet are
E2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
TE logo is a trademark.
*Trademark. Other product names, logos, or company names might be trademarks of their respective owners.
The PRO- - CRIMPER III Hand Crimping Tool is a “Commercial” grade
hand tool and is designed primarily for field installation, repair,
maintenance work, or prototyping in industrial, commercial, or
institutional applications. Product crimped with this tool will meet
the crimp height requirement for hand tools in the appropriate 114 Series
Specification, but may not comply with other feature parameters of the
specification. A variety of tools are offered to satisfy your performance
requirements. For additional information, contact the Tooling Assistance
Center at 1- - 800- - 722- - 1111.
Note: Refer to Catalogs 82004 and 82042 for terminal selection information.
PLASTI--GRIP* Terminal
PLASTI--GRIP* Terminal
PIDG* Terminal or
PIDG FASTON*
PIDG FASTON
Terminal
Family
Product
Die Assembly
Moving
Jaw
Ratchet
Adjustment Wheel
Stationary
Jaw
Insulation
PRO- CRIMPER* III Hand Crimping
Tool Assembly 58433- 3 with
Die Assembly 58423- 1
Yellow
Color
Blue
Blue
Red
Red
TOOLING ASSISTANCE CENTER 1--800--722--1111
PRODUCT INFORMATION 1--800--522--6752
Size (AWG)
Figure 1
22--16
16--14
12--10
22--18
16--14
provided in Section 9, REVISION SUMMARY.
CAUTION
NOTE
i
!
Pivot Pin
Maximum Insulation
Diameter (mm [in.])
Back of Tool
(Wire Side)
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures are
not drawn to scale.
Terminals crimped with Tool 58433- - 3 or with
Die Assembly 58423- - 1 are not Listed by
Underwriters Laboratories Inc. (UL) or CSA
International.
3.56 [.140]
4.32 [.170]
6.35 [.250]
3.56 [.140]
4.32 [.170]
PRO- - CRIMPER III Hand
Crimping Tool Frame
354940- - 1 (408- - 9930)
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
Wire
Moving Handle
Stationary Handle
5.15--5.95 [.203--.234]
5.15--5.95 [.203--.234]
7.94--8.73 [.312--.344]
8 33 9 14 [ 328 360]
8.33--9.14 [.328--.360]
Range (mm [in.])
Strip Length
Instruction Sheet
408- - 9252
11 Mar 11 Rev L
1 of 4
LOC B
