PS7241-2B-F3-A CEL, PS7241-2B-F3-A Datasheet - Page 9

• Manufacturer Part Number: PS7241-2B-F3-A
• Description: SSR OCMOS FET 120MA 2CH NC 8-SOP
• Manufacturer: CEL
• Series: PS, OCMOSr

Specifications of PS7241-2B-F3-A

• Circuit: DPST (2 Form B)
• Output Type: AC, DC
• On-state Resistance: 30 Ohm
• Load Current: 120mA
• Voltage - Input: 1.2VDC
• Voltage - Load: 0 ~ 400 V
• Mounting Type: Surface Mount
• Termination Style: Gull Wing
• Package / Case: 8-SOP
• Load Voltage Rating: 400 V
• Load Current Rating: 120 mA
• Contact Form: Dual Channel Form B
• Output Device: MOSFET
• Mounting Style: Surface
• Relay Type: Solid State
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: PS7241-2BTR

<R>
RECOMMENDED SOLDERING CONDITIONS
(1) Infrared reflow soldering
(2) Wave soldering
(3) Soldering by soldering iron
(4) Cautions
• Peak reflow temperature
• Time of peak reflow temperature
• Time of temperature higher than 220°C
• Time to preheat temperature from 120 to 180°C
• Number of reflows
• Flux
• Temperature
• Time
• Preheating conditions
• Number of times
• Flux
• Peak temperature (lead part temperature)
• Time (each pins)
• Flux
• Fluxes
(a) Soldering of leads should be made at the point 1.5 to 2.0 mm from the root of the lead.
(b) Please be sure that the temperature of the package would not be heated over 100°C.
Avoid removing the residual flux with freon-based and chlorine-based cleaning solvent.
260°C or below (molten solder temperature)
10 seconds or less
120°C or below (package surface temperature)
One
Rosin flux containing small amount of chlorine (The flux with a maximum chlorine
content of 0.2 Wt% is recommended.)
Recommended Temperature Profile of Infrared Reflow
120˚C
(preheating)
120±30 s
Data Sheet PN10305EJ02V0DS
350°C or below
3 seconds or less
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
180˚C
260°C or below (package surface temperature)
10 seconds or less
60 seconds or less
120±30 s
Three
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
Time (s)
(heating)
to 60 s
to 10 s
260˚C MAX.
220˚C
PS7241-2B
9