HE2AN-Q-AC24V Panasonic Electric Works, HE2AN-Q-AC24V Datasheet - Page 9

• Manufacturer Part Number: HE2AN-Q-AC24V
• Description: RELAY POWER 25A 24VAC NEMA
• Manufacturer: Panasonic Electric Works
• Series: HEr
• Type: Power Relayr

Specifications of HE2AN-Q-AC24V

• Relay Type: General Purpose
• Contact Form: DPST (2 Form A)
• Contact Rating (current): 25A
• Switching Voltage: 277VAC
• Coil Type: Standard
• Coil Current: 74mA
• Coil Voltage: 24VAC
• Turn On Voltage (max): 16.8 VAC
• Turn Off Voltage (min): 3.6 VAC
• Mounting Type: Chassis Mount
• Termination Style: Quick Connect - .250" (6.3mm)
• Circuit: DPST (2 Form A)
• Contact Rating @ Voltage: 25A @ 277VAC
• Control On Voltage (max): 16.8 VAC
• Control Off Voltage (min): 3.6 VAC
• Relay Construction: Non-Latching
• Contact Arrangement: DPST-NO
• Coil Voltage Ac: 24V
• Voltage Rating (vdc): 30V
• Voltage Rating (vac): 277V
• Dropout Volt (min): 3.6VACV
• Coil Resistance: 300Ohm
• Pick-up Voltage (max): 16.8VAC
• Maximum Power Rating: 6.925KVA
• Operate Time: 30ms
• Contact Current Rating: 25A
• Contact Material: Ag
• Coil Suppression Diode: No
• Push To Test Button: No
• Led Indicator: No
• Seal: Unsealed
• Product Height (mm): 46.2mm
• Product Depth (mm): 33mm
• Product Length (mm): 60mm
• Operating Temp Range: -50C to 55C
• Pin Count: 6
• Mounting Style: Flange
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 255-1663

HE RELAY ACCESSORIES
MOUNTING METHOD
1. Relay mounting
NOTES
1. Be careful not to drop the relay. It is
made of heat-hardened resin and may
break.
2. Be sure to tighten the screw-down
terminals firmly. Loose terminals may
lead to the generation of heat.
3. When the 1 Form A is used in
situations covered by the Japanese
Electrical Appliance and Material
Control Law, the use of 5.5 mm
cabling and 30 A current is not
allowed. Consequently, the circuit
should be less than 20 A.
2
All Rights Reserved © COPYRIGHT Panasonic Electric Works Co., Ltd.
2. Installing to a DIN rail
4. When fixing the terminal socket with
screws, to avoid torque damage and
distortion, apply torque within the
ranges shown below.
M3.5 screws:
0.784 to 0.98 N·m (8 to 10 kgf·cm)
M4 screws:
1.176 to 1.37 N·m (12 to 14 kgf·cm)
Push
3. Removing from a DIN rail
Flat-head screwdriver