EPSILON5-UPG15 Equinox Technologies, EPSILON5-UPG15 Datasheet - Page 59

• Manufacturer Part Number: EPSILON5-UPG15
• Description: UPGRADE EPSILON ATMEL AT91SAM7
• Manufacturer: Equinox Technologies
• Series: Epsilon5r
• Type: Upgrade Kitr

Specifications of EPSILON5-UPG15

• For Use With/related Products: Epsilon5
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

3.5 Target System powers the Programmer
3.5.1 Overview
In this scenario, the programmer is powered from the Target System via the ISP cable. The Jumper
J9 is fitted which connects the Target Vcc voltage (V_TVCC) to CON1 VIN. This powers the internal
circuitry of the programmer.
Explanation of operation:
•
•
•
3.5.2 Hardware Setup - Target System powers the Programmer
Please note
48
When the ISP Cable is connected from the programmer to a Target System and the Target
system power supply is switched ON, the programmer will power up.
When the ISP Cable is disconnected from the Target System or the Target System is powered
OFF, the Programmer will power OFF.
The programmer should only be connected/disconnect from the Target system when the Target
power supply is switched OFF
•
•
•
The external voltage applied to the programmer must be between 3.1 and 5.0V!
The Target System must be able to supply the worst case current required during a
programming operation – see section 1.5.3.
A 6V2 5W zener diode is internally connected across the programmer supply to protect
against over-voltage.
EPSILON5 MKII Programmer - User Guide V1.12 – 1
st
August 2007