HS7616KCI01H Renesas Electronics America, HS7616KCI01H Datasheet - Page 216

• Manufacturer Part Number: HS7616KCI01H
• Description: ON CHIP DEBUG EMULATOR
• Manufacturer: Renesas Electronics America

Specifications of HS7616KCI01H

• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Table 6.6 Commands for Setting Software Breakpoints
Note: O: Can be set by the BREAKCONDITION_SET command.
Notes on Setting the Hardware Break Condition:
1. When [Go to cursor], [Step In], [Step Over], or [Step Out] is selected, the settings of Break
2. Setting of Break Condition 4 is disabled when an instruction to which a software breakpoint
3. If a PC break before execution is set to the delay slot instruction after a delayed branch
4.
5.
6.5.3
1. When an odd address is set, the address is rounded down to an even address.
2. A software break is accomplished by replacing instructions. Accordingly, it can be set only to
3. During step execution, a software breakpoint is disabled.
192
Channel
Break Condition 1,2
Break Condition 3,4
Condition 4 are disabled.
has been set is executed. Accordingly, do not set a BREAKPOINT to an instruction which
satisfies Break Condition 4.
instruction, user program execution cannot be terminated before the delay slot instruction
execution; execution stops before the branch destination instruction.
the RAM area. However, a software break cannot be set to the following addresses:
Settings of BREAKPOINT and Break Condition 1,2,3,4 are invalid while the STEP OVER
function is being used.
When a Break Condition is satisfied, emulation may stop after two or more instructions have
been executed.
An address whose memory content is H'0000
An area other than RAM
An area of address H’40000000 and the followings
An instruction in which Break Condition 4 is satisfied
A delay slot instruction of a delayed branch instruction
A lower 16-bit address of the 32-bit DSP instruction
X: Cannot be set by the command.
Notes on Setting the [Breakpoint] Dialog Box
Condition
Address Bus
Condition
(<addropt>
option)
O
O
Data
Condition
(<dataopt>
option)
O
X
Access Type
Condition
(<accessopt>
option), Read or
write condition
(<r/wopt> option)
O
O
Count condition
(<Countopt>
option)
O
X