HS2339KCM01H Renesas Electronics America, HS2339KCM01H Datasheet - Page 38

• Manufacturer Part Number: HS2339KCM01H
• Description: ON CHIP DEBUG EMULATOR
• Manufacturer: Renesas Electronics America

Specifications of HS2339KCM01H

• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Note: When installing the PCI card emulator, note the following:
2.4
(1) The connector must be installed to the user system. Table 2.1 shows the recommended
Table 2.1 Recommended Connector
Type Number
2514-6002
Note: When the connector is used, do not install any components within 3 mm of the
(2) The pin arrangement of the connector is shown in section 6.2, Pin Arrangement of the Hitachi-
(3) Figure 2.4 shows how to connect the user system interface cable to the user system. Connect
12
connector for the emulator.
UDI Port Connector.
the ground line of the cable to the user system ground. The end of the ground line has a hole
having a diameter of 3 mm, and therefore, when the ground line is screwed to the user system,
the screw diameter must be 3 mm.
1. Turn off the host computer.
2. Insert the emulator into the PCI slot in parallel.
3. Screw in the emulator after confirming the connector and cable positions.
connector.
Figure 2.4 Connecting the User System Interface Cable to the User System
Connecting the Card Emulator with the User System
Manufacturer
3M Limited
Specifications
14-pin straight type