M3062PT-EPB Renesas Electronics America, M3062PT-EPB Datasheet - Page 49

• Manufacturer Part Number: M3062PT-EPB
• Description: EMUL PERSONALITY KIT M16C/62P
• Manufacturer: Renesas Electronics America

Specifications of M3062PT-EPB

• Accessory Type: Probe Accessory Kit
• For Use With/related Products: PC7501, M16C/62
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

4.1.4 LED Display When the PC7501 Starts Up Normally
Figure 4.1 shows upper panel LED lighting status when the emulator started up properly. Check it
when starting up the emulator system.
Figure 4.1 LED display of the PC7501 when the power turned on
Note on Memory Expansion or Microprocessor Mode:
Note on the Target Status POWER LED:
Note on the Target Status CLOCK LED:
SYSTEM
STATUS
POWER
ERROR
SAFE
• To use the memory expansion or microprocessor mode, be sure to set pins RDY* and
• If your MCU has two or more Vcc terminals, the LED does not light unless power
• If the LED is not turned on, check the following.
(1) After powering on the PC7501 (before starting up the emulator debugger):
(2) After the emulator debugger is started up (after the Init dialog box settings are
HOLD* so that they are not active at startup. Otherwise the emulator system will not
start up correctly.
is supplied to all the terminals.
Make sure that the oscillator circuit board is properly installed in the PC7501 and
it is oscillating normally.
completed):
Make sure that the oscillator selected in the Init dialog box is oscillating normally.
TARGET
POWER
CLOCK
RESET
RUN
WARNING
STATUS
• If this LED does not light, check the voltage of the target system.
• Check that power is supplied to all the power terminals.
• When the target system is not connected, this LED does not light.
( 47 / 80 )
IMPORTANT
: ON
: OFF
: Flashing