INDART-ONE/FSL SofTec Microsystems SRL, INDART-ONE/FSL Datasheet - Page 56

• Manufacturer Part Number: INDART-ONE/FSL
• Description: PROG/DEBUG FOR HC08/HCS08/HCS12
• Manufacturer: SofTec Microsystems SRL
• Series: inDARTr
• Type: In-Circuit, Real-Time Debugger/Programmerr

Specifications of INDART-ONE/FSL

• Contents: In-circuit debugger/programmer unit, Cables, Evaluation Board and Software
• For Use With/related Products: Freescale HC08/S08/RS08/S12/S12X
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 520-1038; INDART-ONE

4
Programming
4.3 BDM Programming Notes
54
The “Mass Erase” operation always blanks the device (even if the
device is protected or secured) and “unsecures” the device (the FLASH
Options/Security Byte location is programmed with 0xFE).
The “Blank Check” operation doesn’t blank check the FLASH
Options/Security Byte location.
The “Program” operation automatically verifies the programmed data,
by reading back the programmed data and checking it against the buffer
sent to the target device. The “Verify” operation is much more secure
(but slower), since it reads back the programmed data and checks it
against the data buffer present in the host PC.
In case of verifying error, please verify the value programmed to the
FLASH Options/Security Byte location. The bit 0 of this byte is always
programmed to 0, so any attempt to program it to 1 will cause a
verifying error.
The “Read”, “Program” and “Verify” operations are performed (when
possible) by setting the target microcontroller’s PLL peripheral so that
the maximum BDM communication speed is achieved.
In the “Auto” operation, a “Run” option is available which, if enabled,
resets the microcontroller and runs the user application at the end of
programming.