AD9956-VCO/PCB Analog Devices Inc, AD9956-VCO/PCB Datasheet - Page 19
![no-image](/images/manufacturer_photos/0/0/57/analog_devices_inc_sml.jpg)
AD9956-VCO/PCB
Manufacturer Part Number
AD9956-VCO/PCB
Description
BOARD EVAL 14BIT 1.8V 48LFCSP
Manufacturer
Analog Devices Inc
Specifications of AD9956-VCO/PCB
Module/board Type
Evaluation Board
For Use With/related Products
AD9956
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
CML DRIVER
For clocking applications, an on-chip current mode logic
(CML) driver is included. This CML driver generates very low
jitter clock edges. The outputs of the CML driver are current
outputs and drives PECL levels when terminated into a 100 Ω
load. The base output current of the driver is programmed by
attaching a resistor from the DRV_RSET pin to ground (nomi-
nally 4.02 kΩ for a continuous current of 7.2 mA). An optional
on-chip current programming resistor is enabled by setting a bit
in the control register. The rising edge and falling edge slew
rates are independently programmable to help control over-
shoot and ringing through the application of surge current
during rising edge transitions and falling edge transitions (see
Figure 27). There is a default surge current of 7.6 mA on the
rising edge and 4.05 mA on the falling edge. Bits in the control
register enable additional rising edge and falling edge surge
current, as well disable the default surge current (see the
Control Function Register Descriptions section for details). The
CML driver can be driven by the
•
•
•
RF divider input
RF divider output
PLLOSC input
Rev. A | Page 19 of 32
I(t)
CML Clock Driver, as Opposed to the Steady State Continuous Current
Figure 27. Rising Edge and Falling Edge Surge Current Output of the
~250ps
RISING EDGE SURGE
~250ps
CONTINUOUS
FALLING EDGE SURGE
t
CONTINUOUS
AD9956