QTM300CA Atmel, QTM300CA Datasheet - Page 2

• Manufacturer Part Number: QTM300CA
• Description: ADAPTER CLONING FOR QT3XX
• Manufacturer: Atmel
• Series: Quantumr

Specifications of QTM300CA

• Convert From (adapter End): *
• Convert To (adapter End): *
• For Use With/related Products: QT300
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 427-1038

Quick Start
Details
Board
To begin using the board right away
Note that the cloning adapter is tolerant of power sequencing; it does not matter
whether the cloning adapter or target is powered first.
Power Connector
This screw terminal strip is used to power the board. The voltage should be between +8
and +20 volts DC. Power should be free from switching noise and short-term fluctua-
tions for best performance. A 9V battery is ideal but make sure the battery does not
drain to below 8V or erroneous operation can occur.
RS232 DB9 Connector
This connector provides communications between the QTM300CA and the PC. It allows
the user to upload or download setups from the cloning adapter to the target QT3xx
device.
Cloning Cable
The clone cable connects to the target board and can be connected whether or not the
target is powered or not. The cable is striped and should not be inserted backwards; the
stripe connects to pin 1 of the E3A or E3B board.
1. Connect the board to a PC using the RS232 serial cable (included). Make sure the
2. Connect the board to the target board’s cloning header (either E3A for QT300 or
3. Run QT3View on the PC (found on the supplied CD or from our website).
4. Attach the 9V battery snap or other power leads to the board’s power terminal
5. Turn on the target boards power.
serial port is not being used by any other application or driver.
E3B for QT310 and QT320).
block.
QTM300CA/R1.00 03/02