IE-789842-NS-EM1 Renesas Electronics America, IE-789842-NS-EM1 Datasheet - Page 28

• Manufacturer Part Number: IE-789842-NS-EM1
• Description: BD EMULATOR 78K0S UPD789842
• Manufacturer: Renesas Electronics America

Specifications of IE-789842-NS-EM1

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

26
(b) When using a crystal oscillator
<2> Prepare the IE-789842-NS-EM1.
<3> Remove the crystal oscillator that is mounted in the IE-789842-NS-EM1’s X1 socket.
<4> Connect the parts board (from <1> above) to the X1 socket from which the crystal oscillator was
<5> Make sure that the parts board is wired as shown in Figure 3-7 above.
<6> Install the IE-789842-NS-EM1 in the IE-78K0S-NS or IE-78K0S-NS-A.
The above steps configure the following circuit and enable supply of the clock from the mounted resonator
to the emulation device.
•
<Steps>
<1> Prepare the IE-789842-NS-EM1.
<2> Remove the crystal oscillator that is mounted in the IE-789842-NS-EM1’s X1 socket.
<3> Connect a crystal oscillator to the X1 socket from which the crystal oscillator was removed (in <2>
Items to be prepared
• Crystal oscillator (see pinouts shown in Figure 3-8)
removed. Check the pin 1 mark to make sure the board is mounted in the correct direction.
above). Insert the pins of the crystal oscillator into the socket aligning the pins as shown in the figure
below.
Figure 3-8. Crystal Oscillator
GND
CHAPTER 3
NC
User’s Manual U14545EJ2V0UM
INSTALLATION
CLOCK OUT
V
CC