E62633R Renesas Electronics America, E62633R Datasheet - Page 4

• Manufacturer Part Number: E62633R
• Description: DEV EMULATOR BASE UNIT H8S/2633
• Manufacturer: Renesas Electronics America
• Type: Microcontrollerr

Specifications of E62633R

• Contents: E6000 Emulator Unit and 4 Logic Probes
• For Use With/related Products: H8S/2633, 264x, 269x, 223x, 262x
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

1.6 Display of the Memory Content and Operation of Memory
1.7
1.6.1
1.6.2
• Memory Content after Execution of a Memory Test
• MT Command
1.6.3
1.6.4
1.7.3
1.7.4
1.7.1
1.7.2
Updating the content of the [Memory] window during execution of the user program when either of the
following conditions is satisfied causes the displayed values to be incorrect:
In those cases, the correct values will be displayed when the content of the window is updated after the
program has stopped. This also applies to the windows [Disassembly], [Image View], [IO], [Watch], and
[Waveform].
Updating of the [Monitor] window or [Watch] window by reading values with the monitoring function is
available even with those conditions.
Do not select the V/N option in the MEMORY_MOVE command. Writing to memory by the
MEMORY_MOVE command always requires verification.
The Load/Save of File
When you specify a download module for debug settings, do not select 4 or 8 for [Access size] in the
[Download Module] dialog box.
No program in the SYSROF format can be loaded. Any program for debugging must be created in the
Elf/Dwarf2 format.
Do not specify V in the FILE_LOAD command. Use the FILE_VERIFY command to verify memory.
The content of memory cannot be saved in the Elf/Dwarf2 format.
The content of memory in the specified range after execution of a memory test will not be guaranteed.
The contents of windows that display memory, such as the [Memory] window, are not automatically
updated after a memory test. Be careful if you want to continue debugging.
When an incorrect parameter has been specified for the MT command, the command line window may
display the message “UNKNOWN ERROR –nnnnnnnnnn”. Enter the correct parameter. The command
line window displays the message “Open this document” after ending the MT command. Ignore this
message because it is not concerned with the result of the MT command.
The memory copy, memory compare, memory fill, and memory test functions are not available during
execution of the user program. These command lines are not available either.
[Enable read and write on the fly] in the [Configuration Properties] dialog box has been disabled
Stepping (step-in, step-over, or step-out) is being performed
The emulator is in sleep mode, software standby mode, watch mode, or subsleep mode.
Operating Memory during Execution of the User Program
Memory Test
Updating the Memory Content during Execution of the User Program
MEMORY_MOVE Command
Access Size of Download Modules
Loading a File in the SYSROF Format
FILE_LOAD Command
FILE_SAVE Command
2 / 5